Do not place CDs, record jackets,
owner’s manuals or other paper on top of
or beneath the unit or in between prod-
ucts containing amplifiers in a stack. This
will block the air flow, causing degraded
performance and a possible fire hazard.
20. Power Sources. This product should
be operated only from the type of power
source indicated on the marking label. If
you are not sure of the type of power
supply to your home, consult your prod-
uct dealer or local power company. For
products intended to operate from
battery power, or other sources, refer to
the operating instructions.
21. Grounding or Polarization. This
product may be equipped with a
polarized alternating-current line plug (a
plug having one blade wider than the
other). This plug will fit into the power
outlet only one way. This is a safety fea-
ture. If you are unable to insert the plug
fully into the outlet, try reversing the plug.
If the plug should still fail to fit, contact
your electrician to replace your obsolete
outlet.
Do not defeat the safety purpose of the
polarized plug.
22. Power-Cord Protection. Power-supply
cords should be routed so that they are
not likely to be walked on or pinched by
items placed upon or against them, pay-
ing particular attention to cords at plugs,
convenience receptacles, and the point
where they exit from the product. To
avoid safety hazards, use only the power
cord supplied with your unit. If a replace-
ment cord is used, make certain that it is
of a similar gauge. We do not recommend
using extension cords with this product.
As with all electrical devices, do not run
power cords under rugs or carpets or
place heavy objects on power cords.
Damaged power cords should be
replaced immediately, by a qualified
service technician, with cords meeting
factory specifications. When disconnect-
ing the power cord from an AC outlet,
always pull the plug; never pull the cord.
23. Non-use Periods. The power cord of
the product should be unplugged from
the outlet when left unused for long
periods of time.
24. Lightning. For added protection for
this product during a lightning storm, or
when it is left unattended and unused for
long periods of time, unplug it from the
wall outlet and disconnect the antenna or
cable system. This will prevent damage
to the product due to lightning and
power-line surges.
25. Overloading. Do not overload wall
outlets, extension cords, or integral con-
venience receptacles, as this can result
in a risk of fire or electric shock.
26. Damage Requiring Service. Unplug
this product from the wall outlet and refer
servicing to qualified service personnel
under the following conditions:
a. The power-supply cord or the plug has
been damaged; or
b. Objects have fallen, or liquid has been
spilled into, the product; or
c. The product has been exposed to rain
or water; or
d. The product does not operate normally
when following the operating instruc-
tions. Adjust only those controls that
are covered by the operating instruc-
tions, as an improper adjustment of
other controls may result in damage
and will often require extensive work
by a qualified technician to restore the
product to its normal operation; or
e. The product has been dropped, or the
enclosure damaged; or
f. The product does not appear to
operate normally or exhibits a marked
change in performance.
27. Servicing. Do not attempt to service
this product yourself, as opening or
removing covers may expose you to
dangerous voltage or other hazards.
Refer all servicing to qualified service
personnel.
28. Object and Liquid Entry. Never push
objects of any kind into this product
through openings, as they may touch
dangerous voltage points or short-out
parts that could result in a fire or electric
shock. Never spill liquid of any kind on
the product. The apparatus shall not be
exposed to dripping or splashing and no
objects filled with liquids, such as vases,
shall be placed on the apparatus.
29. Heat. The product should be situated
away from heat sources such as radia-
tors, heat registers, stoves or other prod-
ucts (including amplifiers) that produce
heat. Avoid installation in extremely hot
or cold locations, in an area that is
exposed to direct sunlight or near heating
equipment. When positioning the product
in its final location, make certain that it
has adequate ventilation on all sides, as
well as on the top and bottom.
English
To Next Page
Loading...
Need help?
General
Weight and Dimensions
