3
www.jbl.com
When the OnBeat Venue LT is in the standby mode it will automatically turn on when it
detects audio playing from a Bluetooth-connected device or from a docked device.
When the OnBeat Venue LT is on, it will automatically enter the standby mode after 10
minutes of inactivity (no audio input and no user-control operation).
Note: When the OnBeat Venue LT enters the standby mode it will also bring a docked
device into standby mode.
Volume Up/Down buttons: Press these buttons to raise and lower the OnBeat Venue LT’s
volume. To mute the sound, press both buttons at the same time. (The Power button LED
will flash white when the sound is muted.) To restore the sound press either Volume button
or both buttons together.
Docking slide: Press in on the JBL logo to open the docking slide and pull the slide all
the way open.
Docking connector: Place your device onto the docking slide so that it is firmly seated
on the docking connector.
Made for
iPhone 5
iPod nano 7th generation
iPod touch 5th generation
Note: We recommend that you disable the”Shake to Shuffle” feature on your iPod nano,
iPod touch and iPhone before docking the device on the OnBeat Venue LT.
BLUETOOTH WIReLeSS StReamInG
To wirelessly stream audio to the OnBeat Venue LT from a Bluetooth-enabled device:
1. If the OnBeat Venue LT’s Bluetooth LED is not flashing blue, press the Source button
until the Bluetooth LED begins flashing blue.
2. Place the Bluetooth-capable device in the pairing mode. Use the device’s Bluetooth
pairing menu to pair with OnBeat Venue LT. (If the device requires a pairing code, use
0000.)
3. When OnBeat Venue LT’s Bluetooth LED illuminates blue continually, it is paired with
the device and you can stream audio via Bluetooth from the device to the OnBeat
Venue LT.
To disconnect the Bluetooth device, press and hold the Source button. To pair OnBeat Venue
LT with a different Bluetooth-enabled device, repeat Steps 2 and 3 with the new device.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
