406, 407 & 409
28
29
Please see operator manual for full details.
Troubleshooting/FAQs Your Notes
Issue / FAQ Resolution/Answer
Machine will not start
Ensure all functions are in neutral, High flow is not engaged
and Hand brake is applied before starting.
Machine Hydraulics will not operate
Ensure Engine is running, Hydraulics have been
activated using the Isolation switch.
Code not excepted by immobiliser
Ensure code is current and entered correctly, Be sure sequence
is followed If locked out turn on ignition and leave for 15 minutes
the system will reset to try again with current codes
Coded Key does not work
Ensure the key has not been near electrical items
The coded key is up to date
Use Coded key to re-programme extra keys
Check Machine battery has charge to turn machine over.
Qhitch does not unlock
Check the Q hitch activation switch
Ensure Hydraulics are active
Check locking pins are free from debris and can mve freely check
electrical connections
Quick release couplings
do not engage
Check all pressure has been vented from Machine
Check all pressure has been vented from attachment
(over time attachments can creep) please store all attachments
in the closed position.
Check coupling are free from contamination and dirt
Machine will not drive
Ensure Hand brake has been released
Check speed setting (start in Turtle)
If engaging motorway mode be sure to follow procedure safely
and seatbelt fastened.
Joystick
Isolation
GearChangeSwitch
(High Speed)
Constant Flow
selector
Constant flow
selector High
Flow
Joystick Isolation
To Next Page
Loading...
Need help?
General
