Specifications:
Enclosure Type: Acoustical Suspension (Sealed)
Driver Type: 10W3v3-3-2
Nominal Impedance: 2Ω
Cont. Power Handling: 500Watts
JL Audio recommends using a high quality amplifier such as the JL Audio XD300/1v2. The diagram below shows the
recommended crossover settings for the XD300/1v2 when being used to power your Stealthbox®.
Included Hardware:
(1) 3”x3” Wax Square
(1) 3/8”-16 X 3” Socket Set Screw
(1) 3/8” Flat Washer
(1) 3/8” Fender Washer
(1) 3/8” Split Lock Washer
(1) 3/8” Hex Nut
10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111
The JL Audio XD300/1v2 is a very versatile audio component. Please consult the owner’s manual for detailed informa-
tion about installing and tuning this amplifier.
STEP 7: At this time, run speaker cable to the
Stealthbox location and check for proper operation
of the woofer.
STEP 8: Remove the wax square from the floor
and expose 1-1/2” of the socket set screw out of
the Stealthbox.
STEP 9: Place the Stealthbox back into the pas-
senger’s side cavity. Carefully inserting the socket
set screw through the drilled floor.
STEP 10: Place the supplied fender washer, flat
washer, lock washer and then hex nut, onto the
exposed socket set screw.
Note: 2009-Up models may require slightly
bending the heat shield above the exhaust to
access the set screw.
Note: Some models may require cutting and
removal of the underseat carpet and/or carpet
padding to access the set screw.
SB-D-QDRAM/10W3v3, JL AUDIO, Inc 2018
Sheet SKU#011163 Revision 11.02.2018Page 2
www.jlaudio.com
Mid/High Frequency Driver Information:
CONGRATULATIONS!
INSTALL COMPLETE.
Front Location Driver Size:
6”x 9”
Applicable JL Audio Products:
C1-690x, C1-690tx, C1-690, & C2-690x
Rear Location Driver Size:
6.0”
Applicable JL Audio Products:
C1-650x, C1-650, C2-600x, C3-600
Cont.
From
Previous
Page
Difficulty Of Installation:
To Previous Page
Loading...
Need help?
General
