CLEANING
The Epic2 is 100% splashproof, sweatproof + washable with an IP55 rating. Simply rinse off your earbuds after use.
Note: Keep charging port tightly sealed when rinsing.
JLABAUDIO.COM
WARNING
Make sure USB door
is closed and fastened.
This will protect against
sweat and water damage.
Before charging, the Epic2 needs to be fully dry.
If there is any exposure to moisture, the internal
components may become damaged.
It is best practice to air dry before charging.
CAUTIONS
• Avoid getting moisture or liquids into the tip of the earbuds
or charging port.
• Avoid extreme heat, cold, and humidity.
• Avoid dropping or crushing the earbuds, stressing the cable by rapid
pulling or extreme force, or bending the cable at a sharp angle.
• Wax may build up in the earbud tips, lowering the sound quality.
Carefully remove the wax with a cotton swab or other small tool to
improve the sound quality.
• If you experience discomfort or pain, try lowering the volume
or discontinuing use temporarily.
• If you experience regular discomfort while using this product,
discontinue use and consult your physician.
• We recommend you treat your earbuds as you would a nice pair
of sunglasses and keep them in safe location when not in use.
WARM-UP YOUR HEADPHONES
Optional: Burn-in is the process for exercising new audio equipment. We recommend 40 hours of burn-in time for most headphones to reach
optimal performance. The main purpose of the process is to loosen the diaphragm of a newly crafted headphone and to stress the headphone
driver. Normal, everyday use can also burn-in the headphones though JLab’s proprietary burn-in provides an ideal mix of sounds and
frequency sweeps to achieve this.
Burn-in your audio equipment with the JLab Audio app available on the App Store and Google Play.
Or access the burn-in method at: jlabaudio.com/burnin
To Previous Page
Loading...
Need help?
General
