EasyManuals Logo
Home>JLab>Headphone>GO AIR POP

JLab GO AIR POP User Manual

JLab GO AIR POP
3 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
FITTING
Connect the GO Air Pop into a computer or USB 5V 1A (or less) output device.
CHARGING CASE
OR
Place the earbud in the
ear canal and slightly
rotate to adjust for best fit.
Try all ear tips for best
fit and proper seal.
CAUTIONS
• Avoid extreme heat, cold, and humidity.
• Avoid dropping or crushing the earbuds.
• Wax may build up in the earbud tips, lowering the sound quality.
Carefully remove the wax with a cotton swab or other small tool to improve the sound quality.
• If you experience discomfort or pain, try lowering the volume or discontinuing use temporarily.
• If you experience regular discomfort while using this product, discontinue use and consult your physician.
• We recommend you treat your earbuds as you would a nice pair of sunglasses and keep them in safe location when not in use.
• The left or right earbud can be used independently for music and phone
calls. Simply choose one and take out of the case to connect.
• Only ONE Bluetooth device can be connected at a time. Turn off
Bluetooth on unwanted devices and turn on Bluetooth on chosen device to
connect.
• Fully dry off earbuds before putting in the charging case to avoid any
damage to the case. The earbuds are sweat/water resistant but the case is
not.
Fully dry off the earbuds before
putting in the charging case to
avoid any damage to the case.
The earbuds are sweat/water
resistant but the case is not.
QUICK TIPS
WARNING
Shop products | Product alerts | Burn-in your headphones
JLab Store + Burn-in Tool
JLAB.COM
Instructional videos at: JLAB.COM/MANUALS
TROUBLESHOOTING
Connection failure or earbuds disconnected from each other (Manual Reset)
1 Keep the earbuds in the charging case and forget “JLab GO Air Pop” from your Bluetooth device settings.
2 Quick tap 7x on one earbud in charging case. Earbud blinks blue 4 times.
3 Quick tap 7x on other earbud in charging case. Earbud blinks blue 4 times.
4 Take both earbuds out of the charging case.
One earbud will be solid white and other will blink blue/white indicating ready to pair to your device.
Charging
Blinks Blue
Fully Charged
Solid Blue

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JLab GO AIR POP and is the answer not in the manual?

JLab GO AIR POP Specifications

General IconGeneral
Control typeTouch
Headset typeBinaural
Product typeHeadphones
Product colorPink
Wearing styleIn-ear
Control unit typeOn-ear control unit
Recommended usageCalls/Music
International Protection (IP) codeIPX4
Battery typeBuilt-in battery
Standby time60 h
Charging sourceUSB
Battery capacity43 mAh
Battery operatedYes
Battery recharge time2.2 h
Continuous audio playback time32 h
Battery recharge time (charging case)2 h
Charging case typeWired
Charging case capacity350 mAh
Charging case connector typeUSB Type-A
Wireless range30 m
Bluetooth version5.1
Bluetooth profilesA2DP, AVRCP, HFP, HSP
Connectivity technologyTrue Wireless Stereo (TWS)
Microphone typeBuilt-in
Microphone sensitivity-42 dB
Weight and Dimensions IconWeight and Dimensions
Weight35.4 g
Charging case weight27.5 g
Left earpiece weight3.7 g

Related product manuals