i- Pilot Wireless Accessory
Do NOT replace the complete i-Pilot as a boxed marine accessory – trouble shoot and replace the defective part!
Connect motor to the voltage appropriate (12/24/36) for the motor being serviced. For Terrova, Riptide Terrova, Ulterra,
Riptide Ulterra, and Ultrex motors the motor must be deployed and the System Ready light “ON” for the motor and
i-Pilot system to function.
Make sure the i-Pilot remote and controller assemblies have the latest software downloaded.
TROUBLESHOOTING
Further information for issues not specific to i-Pilot can be found in the specific model repair manuals.
Part I. General Troubleshooting pages 1 through 6
Part II. Miscellaneous System Information pages 7 through 9
Part III. Remote Quick Reference Guide pages 10 through 16
Please note the differences in the following pictures as they will be referenced throughout this
manual. These are referred to as i-Pilot remotes:
Remote for i-Pilot 1.0 Remote for i-Pilot 1.5 Remote for i-Pilot 1.6
p/n 2994085 p/n 2994170 & p/n 2994171 (Ulterra) p/n 2994075
(Ulterra remote has trim/stow/deploy buttons) (Blue Tooth® enabled i-Pilot system)
The i-Pilot controllers are located in the top control box head. This is where the GPS receiver and
compass is housed. Please note the following differences between the controller decals for i-Pilot
versions 1.0, 1.5, and 1.6.
i-Pilot 1.0 i-Pilot 1.5 i-Pilot 1.6
(Blue Tooth® enabled i-Pilot system)
To Next Page
Need help?
General