CX-500F / MA-500 CX-500F / MA-500
User Manual
Open the rotational button on the xing clip.
Place the xing clip into the ute and fasten the rotational button.
Place the CX-500F into the xing clip.
Adjust the position of CX-500F gooseneck microphone, and it is then ready.
1
2
3
4
MA-500
MIC Input..................
Output......................
Phantom Power........
PAD...........................
Low Cut.....................
Frequency Response
Impedance................
T.H.D.........................
S/N............................
Weight......................
Dimensions(mm)......
4P Mini XLR(Male)
XLR(Male)
12~48V
-10dB
100Hz -6dB
400Hz -4dB
30~20,000Hz
220Ω
<0.045%@1KHz -50dB
>95 dB
40g
Ø20mm*94.5mm(H)
CX-500F
MA-500
/
Condenser Instrument Microphone / Phantom power Adapter
Condenser Instrument Microphone / Phantom power Adapter Condenser Instrument Microphone / Phantom power Adapter
Please maintain the temperature in proper status it helps the Submin-
iature Condenser Instrument Microphone to lengthen its life.
Using the part and adapter made from JTS to ensure the unit quality
and lifetime. Do not attempt to employ non-standard adapters or
connectors as you might damage the unit
59010-091-01
Specication
CX-500F
Type.............................
Frequency Response....
Sensitivity (at 1,000Hz)
Impedance..................
Max.SPL for 1% T.H.D.
Signal-To-Noise Ratio
Output Connector.......
Power Supply.............
Current Consumption
Weight......................
Dimensions(mm)......
Omni-directional Condenser
20~20,000 Hz
-58±3dB*(1.25mV)*0dB=1V/μbar
1.5kΩ
130 dB
68 dB
4P Mini XLR
1-5 VDC
≤0.05mA
8 grams (including cable)
Ø6mm(W)*171mm(H)
The CX-500F is built with full range omni directional capsule with golden plating in and
outside. The at frequency response reproduces all types of utes. Dynamic design of mic
holder can rmly mount CX-500F to utes with dierent sizes while the dual injection
design prevent the ute from scratch. The exible mini gooseneck renders a desirable
miking position while minimizes air stream noises and blasts.
Omni directional pick up pattern
Flat frequency response
Versatile mount clip
Terminated with 4 pin mini XLR for easy wireless application
Phantom power adapter with low cut and pad provided for wired application
Parts ldentication
CX-500F Miniature microphone: 1 piece
MA-500 Adapter: 1 piece
Windscreen (reticular foam cover): 4 pieces
1
2
3
1 2
3
PIN2 OUT(+)
PIN3 OUT(−)
TUPTUO
1
2
3
4
MIC IN
V+
NI CIM
(Phantom Power Supply)
Output: XLR (Male)
Pin 1: GND
Pin 2,3: Audio signal
Input: 4P Mini XLR (Male)
Pin 1: GND
Pin 2: V+
Pin 3,4: Audio signal
4
2
3
1
Need help?
General
