– 125 –
8-12-2. Setting the multi-layered portion changeover timing according to the number of
stitches
If the sensor value drops below the "multi-layered section changeover function OFF threshold" setting,
while the multi-layered section detection is enabled, the sewing parameter automatically returns to the
previous one which is used before turning ON the multi-layered section changeover function.
The aforementioned changeover timing can be changed by setting the number of stitches.
Note that if the sensor value drops below the "multi-layered section changeover function OFF threshold"
setting for the multi-layered section detection even within the range of the number of stitches setting,
the sewing parameter returns to the previous one which is used before turning ON the multi-layered
section changeover function.
[How to set]
1) Press
❶
set the number of stitch-
es to be sewn before carrying out
changeover on the "Multi-layered por-
tion run-on setting list screen".
Factory-set value at the time of delivery : 2
Setting range : 0 to 20
* If this value is set to 0 (zero), the
multi-layered section changeover ON
function by the number of stitches will
be disabled.
2) When you press
❷
, the values
the screen returns to the "Multi-layered
portion sewing parameter list screen".
❶
❷
<Multi-layered portion run-on setting list screen>
To Next Page
Loading...
Need help?
General
