NOTE: Install MX10008 router only in restricted areas, such as dedicated equipment rooms and
equipment closets, in accordance with Articles 110-16, 110-17, and 110-18 of the National Electrical
Code, ANSI/NFPA 70.
General Site Guidelines
This topic applies to hardware devices in the MX10008 routers.
Efficient device operation requires proper site planning and maintenance and proper layout of the equipment,
rack or cabinet (if used), and wiring closet.
To plan and create an acceptable operating environment for your device and prevent environmentally
caused equipment failures:
•
Keep the area around the chassis free from dust and conductive material, such as metal flakes.
•
Follow prescribed airflow guidelines to ensure that the cooling system functions properly and that
exhaust from other equipment does not blow into the intake vents of the device.
•
Follow the prescribed electrostatic discharge (ESD) prevention procedures to prevent damaging the
equipment. Static discharge can cause components to fail completely or intermittently over time.
•
Install the device in a secure area, so that only authorized personnel can access the device.
SEE ALSO
Prevention of Electrostatic Discharge Damage | 343
MX10008 Environmental Requirements and Specifications | 92
Site Electrical Wiring Guidelines
Table 29 on page 95 describes the factors you must consider while planning the electrical wiring at your
site.
94
To Next Page
Loading...
Need help?
General
