SRX210 Services Gateway Quick Start
Use the instructions in this quick start to help you connect the SRX210 Services
Gateway to your network. For details, see the SRX210 Services Gateway Hardware
Guide at http://www.juniper.net/techpubs/a057.html
.
SRX210 Services Gateway (SRX210B, SRX210H, SRX210H-POE) Front
Panel
SRX210 Services Gateway with Integrated Convergence Services
(SRX210H-P-MGW) Front Panel
SRX210 Services Gateway (All Models) Back Panel
SRX210 Services Gateway Models
The following four models of SRX210 Services Gateways are available:
On the SRX210H-POE and SRX210H-P-MGW models, Power over Ethernet (PoE) of 50
watts is supported across 4 ports (0/0, 0/1, 0/2, and 0/3).
Connecting and Configuring the SRX Series Device
Use the instructions below to connect and set up the SRX210 Services Gateway to
protect your network. Refer to the LEDs on the front of the device to help you determine
the status of the device.
Task 1: Overview
The SRX210 Services Gateway is a security device that requires these basic
configuration settings to function:
Interfaces must be assigned IP addresses.
Interfaces must be bound to zones.
Policies must be configured between zones to permit or deny traffic.
Callout Description Callout Description
1 Mini-PIM slot 5 USB ports
2 Power button 6 Console port
3 LEDs (ALARM, POWER,
STATUS, HA, mPIM, EXPCARD)
7 Gigabit Ethernet (0/0 and 0/1) and Fast
Ethernet (0/2 to 0/7) ports
4 Reset Config button
Callout Description Callout Description
1 FXS and FXO voice ports 5 Reset Config button
2 Mini-PIM slot 6 USB ports
3 Power button 7 Console port
4 LEDs (ALARM, POWER, STATUS,
HA, mPIM, EXPCARD)
8 Gigabit Ethernet (0/0 and 0/1) and Fast
Ethernet (0/2 to 0/7) ports
To Next Page
Need help?
General
