Changing the RESET CONFIG Button Behavior on the SRX550 High Memory Services
Gateway
You can change the default operation of the RESET CONFIG button of the services
gateway by limiting how the button resets the services gateway:
•
To prevent the RESET CONFIG button from setting the services gateway to the
factory-default configuration and deleting all other configurations, enter the following
command. You can still press and quickly release the button to reset it to the rescue
configuration.
user@host# set chassis config-button no-clear
•
To prevent the RESET CONFIG button from setting the services gateway to the rescue
configuration, enter the following command. You can still press and hold the button
for 15 seconds or more to reset the services gateway to the factory defaults.
user@host# set chassis config-button no-rescue
•
To disable the button and prevent the services gateway from resetting to either
configuration, enter the following command:
user@host# set chassis config-button no-clear no-rescue
The no-rescue option prevents the RESET CONFIG button from deleting all configurations
on the services gateway.
To return the function of the RESET CONFIG button to its default behavior, remove the
config-button statement from the services gateway configuration.
Related
Documentation
Troubleshooting with the CLI on the SRX550 High Memory Services Gateway on page 145•
• Troubleshooting with LEDs on the SRX550 High Memory Services Gatewayon page 146
• SRX550 High Memory Services Gateway Front Panel on page 14
• Troubleshooting with Chassis and Interface Alarm Messages on the SRX550 High
Memory Services Gateway on page 148
• Troubleshooting the Power System on the SRX550 High Memory Services Gateway
on page 150
• Using the RESET CONFIG Button on the SRX550 High Memory Services Gateway on
page 153
• Resetting the SRX550 High Memory Services Gateway on page 154
Resetting the SRX550 High Memory Services Gateway
Use the RESET CONFIG button to return the SRX550 High Memory Services Gateway to
either the rescue configuration or the factory default configuration. The button is recessed
to prevent it from being pressed accidentally. To press this button, insert a small probe
(such as a straightened paper clip) into the pinhole on the front panel of the chassis.
Copyright © 2016, Juniper Networks, Inc.154
SRX550 High Memory Services Gateway Hardware Guide
To Next Page
Loading...
Need help?
General
