EN
25
12
12: 34 :24
0
30.21
3:71
.
5
2
bi t /SOUND
1
4
6
L
USING MENUS FOR DETAILED ADJUSTMENT
ON SCREEN setting:
For playback sound,
tape speed and tape
running.
DATE/TIME setting:
For date/time.
Display
Minutes
Seconds
Frames*
* 25 frames = 1 second
TIME CODE setting:
For time code.
VIDEO DISPLAY
• Settings made in the “
VIDEO DISPLAY” Menu are
effective only for tape playback.
BRIGHT , DATE/TIME , TIME CODE
Refer to “ CAMERA DISPLAY” on page 23, 24.
The factory-preset of “DATE/TIME” in the “
VIDEO
DISPLAY” Menu is “OFF”.
ON SCREEN
OFF: Camcorder's display (except the date, time and
time code) is not shown on LCD or connected TV.
[LCD]: Camcorder's display is shown only on LCD
and not on connected TV (except the date, time and
time code).
LCD/TV: Camcorder's display is shown on both LCD
and connected TV.
Playback Sound
During tape playback, the camcorder detects the sound
mode in which the recording was made, and plays the
sound back. Select the type of sound to accompany
your playback picture. According to the menu access
explanation on pg. 24, select “SOUND MODE” or “12bit
MODE” from the Menu Screen and set it to the desired
parameter.
SOUND MODE
[STEREO ]: Sound is output on both “L” and “R”
channels in stereo.
SOUND L
: Sound from the “L” channel is output.
SOUND R : Sound from the “R” channel is output.
12bit MODE
MIX: Original and dubbed sounds are combined and
output in stereo on both “L” and “R” channels.
[SOUND 1]: Original sound is output on both “L” and
“R” channels in stereo.
SOUND 2: Dubbed sound is output on both “L” and
“R” channels in stereo.
[ ] = Factory-preset
NOTES:
• You can also use the provided remote control’s AUDIO
button R to change the output sound (without having to
access the Playback Menu). Make sure you point the
remote control at the camcorder’s remote sensor 1.
• The camcorder cannot detect the sound mode in which
the recording was made during fast-forward or rewind.
During playback the sound mode is displayed in the upper
left corner.
• The “SOUND MODE” setting is available for both
12-bit and 16-bit sound. (In previous models’ functions,
“12-bit” is called “32 kHz” and “16-bit” is called “48 kHz”.)
–EE
– O
–R
IVDE
O
DISPLAY
TBR I GH
ENEON SC
TIDA METE /
CODTIM
LCD
OFF
FF
RETURN
To Next Page
Loading...
Need help?
General
