Maintenance
How to
dean
the connectors
Frequent detachment will deteriorate the
connectors.
To minimize this possibility, periodically wipe
the connectors
with
a
cotton
swab
or
cloth
moistened
with
alcohol, being careful
not
to
damage the connectors.
To keep discs
dean
A dirty disc may
not
play
correctly.
If
a disc does become
dirty, wipe it
with
a soft cloth
in a straight line from center
to
edge.
• Do
not
use any solvents (for example,
conventional record cleaner, spray, thinner,
benzine, etc.)
to
clean discs.
-
Stick-on label
C-thru
Disc
(semitranspa
re
nt
disc)
•
Unusual shape
Do
not use the following discs:
---------------------,----------
Single
CD-8
cm I .
(3-3/16") disc I Warped disc
I
I
I
,----------------+---------
Sticker and sticker I
residue I
To play new discs
New discs may have some
rough spots around the inner
and outer edges. If such a disc
is
used, this
unit
may reject the
disc.
To
remove these
rough
spots,
rub the edges
with
a pencil or ball-point pen, etc.
I
I
I
--Jam
I
semitransparent I
parts on its recording I
area
!
i
,
i
,
I
i
Center holder
How to handle discs
When
removing a
disc
from
its
case,
press
down
the center holder
of
the
case
and lift the disc out, holding
it by the edges.
• Always hold the disc by the edges. Do
not
touch its recording surface.
When
storing a
disc
in
its
case,
gently
insert
the disc around the center holder (with the
printed surface facing up).
• Make sure
to
store discs
in
cases
after
use.
Connectors
Moisture condensation
Moisture may condense on the lens inside
the
unit
in
the following
cases:
• After starting the heater in the
car.
• If it becomes very humid inside the
car.
Should this occur, the
unit
may malfunction.
In
this
case,
eject the disc and leave the
unit
turned on for a few hours until the moisture
has
evaporated.
ENGLISH
I 29
To Next Page
Loading...
Need help?
General
