JVC KD-AR390 User Manual

12
ENGLISH
3 Adjust the quality slope (Q).
Sound
elements
Range/selectable items
BASS MID TRE
Frequency 60 Hz
80 Hz
100 Hz
120 Hz
500 Hz
1.0 kHz
1.5 kHz
2.5 kHz
7.5 kHz
10.0 kHz
12.5 kHz
15.0 kHz
Level (LVL) –06 to
+06
–06 to
+06
–06 to
+06
Q Q0.5
Q1.0
Q1.5
Q2.0
Q0.75
Q1.0
Q1.25
Q1.5
Q0.75
Q1.25
BASS: Bass MID: Mid-range TRE: Treble
5 Repeat steps 3 and 4 to adjust other sound
characteristics.
The adjustment made will be stored automatically.
Adjusting the sound
You can adjust the sound characteristics to your
preference.
• The adjustment you make will be stored for the
currently selected sound mode (iEQ) including
“USER.”
1
2
FADER *
2
Adjust the front and rear speaker
output balance.
R06 to F06
BALANCE *
3
Adjust the left and right speaker
output balance.
L06 to R06
LOUD *
4
(loudness)
Boost low and high frequencies to
produce a well-balanced sound at a
low volume level.
LOUD ON or
LOUD OFF
SUB.W *
1
(subwoofer)
Adjust the subwoofer output level.
00 to 08,
initial: 04
VOL ADJ (volume adjust)
Adjust the volume level of each source
(except FM), compared to the FM
volume level. The volume level will
automatically increase or decrease
when you change the source.
• Before making an adjustment, select
the source you want to adjust.
–05 to +05,
initial: 00
VOLUME
Adjust the volume.
00 to 50 or
00 to 30 *
5
*
1
Displayed only when “L/O MODE” is set to “SUB.W”
(see page 14).
*
2
If you are using a two-speaker system, set the fader
level to “00.”
*
3
This adjustment will not affect the subwoofer output.
*
4
Loudness setting will be applied to all sound modes.
*
5
Depending on the amplifier gain control setting. (See
page 14 for details.)
EN08-13_KD-G446_001A_2.indd 12EN08-13_KD-G446_001A_2.indd 12 11/29/07 4:35:07 PM11/29/07 4:35:07 PM

JVC KD-AR390 Specifications

General

Brand	JVC
Model	KD-AR390
Category	Car Receiver
Language	English