JVC KD-DV4405 Installation & Connection Manual

3
B
Connecting the parking brake wire
When installing the monitor in a location where it can be seen by the driver
Connect the parking brake wire to the parking brake system built in the car.
When installing the monitor in a location where it cannot be seen by the driver
Connect the parking brake wire to metallic body or chassis of the car.
Connecting the crimp connector
C
Parking brake wire (light green)
To metallic body or chassis of the car
Parking brake switch (inside the car)
Parking brake
Parking brake wire (light green)
To external components (see diagram )
Light green
VIDEO OUT (see diagram
)
DIGITAL OUT
(see diagram
)
A
To parking brake, metallic body or chassis of the car
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1 Connect the colored leads of the power cord in the order specified in the illustration below.
2 Connect the antenna cord.
3 Finally connect the wiring harness to the unit.
15 A fuse
Black
Blue with white stripe
Red
Yellow
*
2
To metallic body or chassis of the car
Ignition switch
Fuse block
To an accessory terminal in the fuse block
To the remote lead of other equipment (200 mA max.)
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
*
1
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.
Line out (see diagram
)
Rear ground terminal
Left speaker (front)
Right speaker (front) Left speaker (rear) Right speaker (rear)
PurplePurple with black stripeGreenGreen with black stripeGrayGray with black stripeWhiteWhite with black stripe
Wire connecting the battery and the parking brake switch.
Attach the parking brake wire to this point.
Contact the metallic part of the crimp to the wires inside.
Pinch the crimp firmly.
Typical connections
ELECTRICAL CONNECTIONS
Antenna terminal
To the automatic antenna if any (250 mA max.)
Blue
Instal3-4_DV4406_009A_f.indd 3Instal3-4_DV4406_009A_f.indd 3 12/4/07 6:09:13 PM12/4/07 6:09:13 PM

JVC KD-DV4405 Specifications

General

Brand	JVC
Model	KD-DV4405
Category	Car Receiver
Language	English