EasyManuals Logo
Home>JVC>Car Receiver>KD-R721BT

JVC KD-R721BT Installation & Connection Manual

JVC KD-R721BT
2 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
2
*
1
Not supplied for this unit.
*
2
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated
with paint.
*
3
Make the <L/O MODE> setting accordingly, see page 24 of the INSTRUCTIONS.
*
1
Non fourni avec cet appareil.
*
2
Attachez solidement le fil de mise à la masse au châssis métallique de la voiture—à un endroit qui n’est pas
recouvert de peinture.
*
3
Réalisez le réglage <L/O MODE> en fonction, voir page 24 du MANUEL D’INSTRUCTIONS.
ELECTRICAL CONNECTIONS / RACCORDEMENTS ELECTRIQUES
Reset the unit. /
Réinitialisez l’autoradio.
Signal cord /
Cordon de signal *
1
Extension lead /
Fil prolongateur *
1
Remote lead /
Fil d’alimentation à distance
To the blue (white stripe) lead of the unit /
Au fil bleu (bande blanche) de l’appareil
JVC Amplifier /
JVC Amplificateur
Connecting the external amplifiers and/or subwoofer / Connexion d’amplificateurs extérieurs et/ou d’un caisson de grave
Rear ground terminal /
Borne arrière de masse
10 A fuse / Fusible 10 A
Aerial input / Entrée d’antenne
Remote adapter /
Adaptateur de télécommande *
1
For some VW/Audi or Opel (Vauxhall) automobiles / Pour certaines
automobiles VW/Audi ou Opel (Vauxhall)
You may need to modify the wiring of the supplied power cord as illustrated. / Vous
aurrez peut-être besoin de modifier le câblage du cordon d’alimentation fourni comme
montré sur l’illustration.
Contact your authorized car dealer before installing this unit. / Contactez votre
revendeur automobile autorisé avant d’installer l’appareil.
Original wiring / Câblage original
Modified wiring 1 / Câblage modifié 1
Use modified wiring 2 if the unit does not turn on. / Utilisez le câblage modifié 2 si
l’appareil ne se met pas sous tension.
ISO connector /
Connecteur ISO
Y: Yellow / Jaune
R: Red / Rouge
Modified wiring 2 / Câblage modifié 2
IMPORTANT/IMPORTANT: A custom wiring harness (separately purchased) which is suitable for your car is recommended for connection between the unit and your car. / Un faisceau de câbles personnalisé (vendu
séparément) correspondant à votre voiture est recommandé pour raccorder l'appareil et votre voiture.
Consult your JVC IN-CAR ENTERTAINMENT dealer or a company supplying kits for
details about connection. / Pour en savoir plus sur connexions, consultez votre revendeur
d’autoradio JVC ou une compagnie fournissant des kits.
(A) If your car has an ISO terminal / Si votre voiture possède une prise ISO (B) If your car does NOT have an ISO terminal / Si votre voiture ne possède pas de prise ISO
Custom wiring harness (separately purchased) /
Faisceau de fils personnalisé (à acheter séparément)
Custom wiring harness (separately purchased) /
Faisceau de fils personnalisé (à acheter séparément)
B1/B2 Rear speaker, right (Purple/Purple, black stripe) (+/–) / Enceinte arrière, droit (Violet/Violet,
bande noire) (+/–)
B3/B4 Front speaker, right (Gray/Gray, black stripe) (+/–) / Enceinte avant, droit (Gris/Gris, bande
noire) (+/–)
B5/B6 Front speaker, left (White/White, black stripe) (+/–) / Enceinte avant, gauche (Blanc/Blanc,
bande noire) (+/–)
B7/B8 Rear speaker, left (Green/Green, black stripe) (+/–) / Enceinte arrière, gauche (Vert/ Vert, bande
noire) (+/–)
A4 Car battery 12 V (Yellow) / Batterie de la voiture 12 V (Jaune)
A5 Remote lead/power aerial, 200 mA max. (Blue, white stripe) / Fil d’alimentation à distance/
antenne automatique, 200 mA max. (Bleu, bande blanche)
A6 To car light control switch (Orange, white stripe) / À l’interrupteur d’éclairage de la voiture
(Orange, bande blanche)
A7 Accessory terminal (Red) / Prise accessoire (Rouge)
A8 Metallic body/chassis of the car (Black) / Corps métallique/châssis de la voiture (Noir)
E Power cord (supplied) /
Cordon d’alimentation (fournie)
E Power cord (supplied) /
Cordon d’alimentation (fournie)
E Power cord (supplied) /
Cordon d’alimentation (fournie)
ISO connector / Connecteur ISO
Light blue (yellow stripe) /
Bleu clair (bande jaune)
FRONT : To front speakers / Aux enceintes avant
REAR/SW : To rear speakers or subwoofer / Aux enceintes arrière ou
caisson de grave *
3
Connecting the microphone unit / Connexion du
microphone
G
Microphone (supplied) /
Microphone (fournie)
H
Microphone clip (supplied) /
Attache de microphone (fournie)
Secure using cord cramps *
1
if necessary /
Fixez en utilisant des serre-fils *
1
si nécessaire
or / ou
or / ou
Adjust the angle /
Ajustez l’angle
USB cable (approx.
1.2 m) / Câble USB
(environ 1,2 m)
MIC (Microphone input terminal /
Prise d’entrée de microphone)
Install_KD-R721BT_010A_f.indd 2Install_KD-R721BT_010A_f.indd 2 1/21/11 9:57:12 AM1/21/11 9:57:12 AM

Other manuals for JVC KD-R721BT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC KD-R721BT and is the answer not in the manual?

JVC KD-R721BT Specifications

General IconGeneral
MP3 playbackYes
Audio formats supportedMP3, WAV, WMA
Tuner typeHS-IV
Output power200 W
Audio output channels4.0 channels
Maximum power per channel50 W
I/O portsUSB x 2 AUX-IN

Related product manuals