14 ENGLISH
If SETTINGS is selected in step 2 ...
Turn the control dial to select an item
(see below), then press the control dial
to confirm.
The following settings are applicable to
the paired device. If another device is
paired, make the settings again.
•
P. BOOK SEL
*
PB IN PHONE
[Initial] : The unit browses the
phonebook of the connected phone.
PB IN UNIT
: The unit browses the phonebook
registered in the unit. (To copy the phonebook
memory, see <P. BOOK WAIT> on page 17.)
•
If the phonebook contains many numbers, you
can fast search (±10, ±100, ±1 000) through
the phonebook by turning the control dial
quickly.
•
To search through the phonebook, see the right
column.
*
Selectable only when the connected phone
supports PBAP.
•
AUTO ANSWER
ON
: The unit answers the incoming calls
automatically. /
OFF
[Initial] : The unit does not
answer the calls automatically. Press
or the
control dial to answer.
•
RING TONE
IN UNIT
[Initial] : The unit rings to alert you
when a call/Text Message comes in.
–
CALL
: Select your preferred ring tone when a
call comes in [
TONE1
—
5
].
–
MESSAGE
: Select your preferred ring
tone when a text message comes in
[
TONE1
—
5
].
•
Default ring tone is different according to the
paired device.
IN PHONE
: The unit rings using the connected
phones’ ring tone to alert you when a call/Text
Message comes in. (The connected mobile phone
rings if it does not support this feature.)
•
NR/EC MODE
ON
[Initial] : The unit adjusts the Noise
Reduction and Echo Cancellation of the
microphone connected to the unit for clearer
sound. /
OFF
: Cancels.
•
MIC LEVEL
Adjust the sensitivity [
01
/
02
/
03
] of the
microphone connected to the unit. [ Initial:
02
]
•
MSG NOTICE
ON
[Initial] : The unit informs you of the
arrival of a message by ringing and displaying
“RCV MESSAGE”
=
“[Device name].” /
OFF
: The unit does not inform you of the arrival
of a message.
To select a contact from the phonebook
1
Select PHONEBOOK calling method.
(page 13)
2
Press
5
/
∞
to show the search menu
(A to Z, 0 to 9, and OTHERS).
“OTHERS” appear if the 1st character is not
A to Z, or 0 to 9, such as #, —, !, and etc.
3
Press
5
/
∞
to select your desired
character, then press the control dial to
confirm.
The name list of the selected character
appears.
4
Turn the control dial to select your
desired contact, then press to confirm.
• Only the existing characters will be shown on
the search menu.
• Press and hold
5
/
∞
to continuously change
the character of the search menu.
• If your phonebook contains many contacts,
searching take some time.
EN02-29_KD-R728BT[J]_f.indd 14EN02-29_KD-R728BT[J]_f.indd 14 1/12/11 4:47:41 PM1/12/11 4:47:41 PM
To Next Page
Loading...
Need help?
General
