27ENGLISH
Continued...
Symptom Remedy/Cause
USB playback
“READING” keeps flashing on the display. A longer readout time is required. Do not use too many hierarchical
levels and folders. / Turn off the power then on again. / Reattach the
USB device again.
Noise is generated. Skip to another file.
While playing a track, sound is
sometimes interrupted.
The tracks have not been properly copied into the USB device. Copy
tracks again into the USB device, and try again.
Tracks/folders are not played back in the
order you have intended.
The playback order is determined by the file name. Folders with
numbers on the initial of their names are sorted in numerical order.
However, folders with no numbers on the initial of their names are
sorted according to the file system of the USB device.
“USB ERROR
”
=
“
REMOVE USB
”
=
“
PWR OFF/ON” scrolls on the display.
An over-current occurs. Turn off, then turn on the unit.
“NO FILE” appears on the display. Check whether the selected folder, the connected USB device,
or the iPod/iPhone contains a playable file.
“NOT SUPPORT” appears and track skips. Check whether the track is a playable file format.
“CANNOT PLAY” flashes on the display. /
“NO USB” appears on the display. / The
unit cannot detect the USB device.
Check whether the connected USB device is compatible with this
unit. / Reattach the USB device again.
Bluetooth
“PLEASE CNNT BT ADAPTER” scrolls on
the display.
Connect the USB Bluetooth Adapter (KS-UBT1) to the unit before you
can perform any operation.
No Bluetooth device is detected. Search from the Bluetooth device again. / Reset the unit, then search
from the Bluetooth device again.
Pairing cannot be made. Make sure you have entered the same PIN code to both the unit and
target device. / Disconnect the Bluetooth device and try pairing again.
Echo or noise occurs. Adjust the microphone unit’s position.
Phone sound quality is poor. Reduce the distance between the unit and the Bluetooth mobile
phone. / Move the car to a place where you can get a better signal
reception.
The unit does not response when you
tried to copy the phonebook to the unit.
You may have tried to copy the same entries (as stored) to the unit.
Press
DISP
or
BACK
to exit.
The sound is interrupted or skipped during
playback of a Bluetooth audio player.
Reduce the distance between the unit and the Bluetooth audio
player. / Disconnect the device connected for Bluetooth Phone. / Turn
off, then turn on the unit. / Connect the player again, when the sound
is not yet restored.
EN02-29_KD-R728BT[J]_f.indd 27EN02-29_KD-R728BT[J]_f.indd 27 1/12/11 4:47:43 PM1/12/11 4:47:43 PM
To Next Page
Loading...
Need help?
General
