19
Part list for installation
( ×2 )
( ×1 )
( ×1 )
( ×1 )
( ×1 )
A
Faceplate
B
Mounting sleeve
C
Trim plate
D
Wiring harness
E
Extraction key
STEERING
WHEEL
REMOTE
KD-R841BT KD-R741BT
Light blue/yellow
Wiring connection
Signal cord
(not supplied)
Remote wire
(not supplied)
Rear ground terminal
To the steering wheel remote control adapter
Fuse (10 A)
To Blue/white
wire of the wiring
harness
D
Aerial terminal
JVC Amplifier
Front output
Rear/subwoofer output
Rear/subwoofer output
IMPORTANT: A custom wiring harness (separately
purchased) which is suitable for your car is
recommended for connection.
If your car has an ISO terminal
If your car does NOT have an ISO terminal
( or )
( or )
ISO connector
* Custom wiring harness (separately purchased)
For some VW/Audi or Opel (Vauxhall)
automobiles
You may need to modify the wiring of the supplied
wiring harness
D
as illustrated.
If the unit does not turn on with modified wiring 1,
use modified wiring 2 instead.
Y: Yellow R: Red
Original wiring
Modified wiring 1
Modified wiring 2
A4: Yellow: Battery
A5: Blue/white: Remote wire
A6: Orange/white: Car light control
switch
A7: Red: Ignition (ACC)
A8: Black: Earth (ground) connection
B1: Purple
ª
B2: Purple/black
·
Rear speaker
(right)
B3: Gray
ª
B4: Gray/black
·
Front speaker
(right)
B5: White
ª
B6: White/black
·
Front speaker
(left)
B7: Green
ª
B8: Green/black
·
Rear speaker
(left)
MIC (Microphone input terminal) (
➜
9)
ENGLISH
EN_KD-R841BT[E]_f.indd 19EN_KD-R841BT[E]_f.indd 19 10/31/12 9:35:58 AM10/31/12 9:35:58 AM
To Next Page
Loading...
Need help?
General
