14 ENGLISH
3
Use the Bluetooth device to search and
select “JVC Unit.”
• For some Bluetooth devices, you may
need to enter the PIN code first after
search.
4
Perform one of the following pairing
operations (what appear depends on the
Bluetooth device pairing process).
(A) If the following appear on the
display:
Pairing ?
Device: [Device name]
Pairing ?
Yes: Press VOL
No: Press BACK
]
Select “Yes” to start the pairing
process.
If “Now Pairing...” appears...
]
Operate the Bluetooth device to
accept.
If “Now Pairing... PIN code: 0000”
appears...
]
Enter a PIN (Personal Identification
Number) code to the Bluetooth device.
•
You can change the PIN code of your choice
before pairing. (page 19) [
Initial: 0000
]
(B) If the following appear on the
display:
Pairing ?
Device: [Device name]
Passkey: XXXXXX
Pairing ?
Yes: Press VOL
No: Press BACK
]
Check to be sure the passkey appears
on the unit and Bluetooth device is the
same. Then, confirm the passkey on the
unit by pressing the control dial. Operate
the Bluetooth device to confirm the
passkey.
•
“XXXXXX” is a 6-digit numeric code that
appear in different combination (even if the
device is the same) each time pairing is made.
5
After pairing is successful, the unit will
establish Bluetooth connection with the
Bluetooth device*. (“Pairing COMPLETED”
appears and
lights up on the display.)
• The device remains registered even
after you disconnect the device. Use
<Connect Phone/ Connect Audio> (or
activate <Auto Connect>, page 19) to
connect the same device from next time
on.
*
Some devices may not be able to connect to the
unit after pairing. Connect the device to the
unit manually.
To delete a registered device
1
Press and hold MENU.
2
Turn the control dial to select
<Bluetooth>, then press to confirm.
3
Turn the control dial to select
<Delete Pairing>, then press to confirm.
4
Turn the control dial to select a device
you want to delete, then press to confirm.
“Delete OK?” appears.
5
Press the control dial to delete the
selection.
“OK” appears when the device is deleted.
To return to the previous menu, press
T/P BACK.
To connect/disconnect a registered device
1
Press and hold MENU.
2
Turn the control dial to select
<Bluetooth>, then press to confirm.
3
Turn the control dial to select
<Connect Phone/ Connect Audio> or
<Disconnect Phone/ Disconnect Audio>,
then press to confirm.
4
Turn the control dial to select a device
you want to connect/disconnect, then
press to confirm.
“Connected [Device name]/ Disconnected
[Device name]” appears when the device is
connected/disconnected.
EN02-37_KD-R921BT_003A_2.indd 14EN02-37_KD-R921BT_003A_2.indd 14 2/9/11 9:54:41 AM2/9/11 9:54:41 AM
To Next Page
Loading...
Need help?
General
