25
ENGLISH |
Symptom Remedy
Bluetooth®
No Bluetooth device
is detected.
• Search from the Bluetooth device again.
• Reset the unit.
( 3)
Pairing cannot be
made.
• Make sure you have entered the same PIN code to both the
unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again.
( 13)
“PAIRING FULL”
appears.
The number of registered devices has reached its limit. Retry
after deleting an unnecessary device.
( 17, DELETE PAIR)
“PLEASE WAIT”
appears.
The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the unit,
then connect the device again.
“BT DEVICE NOT
FOUND” appears.
The unit failed to search for the registered Bluetooth devices
during
[AUTO CNNCT]
. Turn on Bluetooth from your device
and connect manually.
( 17)
Echo or noise occurs. • Adjust the microphone unit’s position.
( 13)
• Check the
[ECHO CANCEL]
setting.
( 15)
Phone sound quality
is poor.
• Reduce the distance between the unit and the Bluetooth
device.
• Move the car to a place where you can get a better signal
reception.
“NOT SUPPORT”
appears.
The connected phone does not support Voice Recognition
feature.
“ERROR” appears. Try the operation again. If “ERROR” appears again, check if
the device supports the function you have tried.
Symptom Remedy
Bluetooth®
The unit does not respond
when you try to copy the
phonebook to the unit.
You may have tried to copy the same entries (as
stored) to the unit. Press
DISP
or
PTY
to
exit.
Sound is being interrupted or
skipped during playback of a
Bluetooth audio player.
• Reduce the distance between the unit and the
Bluetooth audio player.
• Turn off, then turn on the unit and try to connect
again.
• Other Bluetooth devices might be trying to connect
to the unit.
The connected Bluetooth
audio player cannot be
controlled.
• Check whether the connected Bluetooth audio
player supports Audio/Video Remote Control Profile
(AVRCP). (Refer to the instructions of your audio
player.)
• Disconnect and connect the Bluetooth player again.
“H/W ERROR” appears. Reset the unit and try the operation again. If “H/W
ERROR” appears again, consult your nearest service
center.
“BT ERROR PLS UPDATE”
appears.
Update the Bluetooth firmware.
( 4)
If you have any troubles, try the following:
1 Check TROUBLESHOOTING
2 Reset the unit (
3)
3 Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: http://www.jvc.com
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
