10
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Bluetooth mobile phone
To Do this
Receive a call
Press or the volume knob.
On RM-RK52: Press J / K / H / I .
• When
[AUTO ANSWER]
is set to the selected time, the unit answers
incoming call automatically.
( 11)
Reject an incoming
call
Press and hold or the volume knob.
On RM-RK52: Press and hold J / K / H / I .
End a call
Press and hold or the volume knob.
On RM-RK52: Press and hold J / K / H / I .
Activate or deactivate
hands-free mode
Press the volume knob during a call.
•
Operations may vary according to the connected Bluetooth mobile
phone.
Adjust the phone
volume
Turn the volume knob during a call.
Phone volume:
[00]
to
[50]
(Default:
[15]
)
• This adjustment will not affect the volume of the other sources.
Switch between two
connected phones
Press repeatedly.
• Not applicable during a call.
Improve the sound quality during a call
While talking on the phone....
1 Press and hold MENU.
2 Turn the volume knob to make a selection (see the following table), then press the knob.
3 Press MENU to exit.
To return to the previous setting item or hierarchy, press GT/P.
Default:
XX
MIC LEVEL –20
—
+08
(
0
):The sensitivity of the microphone increases as the number increased.
NOISE RDCT –05
—–
20
(
–10
):Adjust the noise reduction level until the least noise is being heard during a
phone conversation.
ECHO CANCEL 1
—
10
(
4
):Adjust the echo cancellation delay time until the least echo is being heard during a phone
conversation.
BLUETOOTH®
2 Search and select “JVC UNIT” on the Bluetooth
device within 3minutes.
3 Perform (A), (B) or (C) depending on what
appears on the display.
(A) “PAIRING”
“XXXXXX” (6-digit passkey):
Ensure that the same passkey appears on
the unit and Bluetooth device, then operate
the Bluetooth device to confirm the passkey.
(B) “PAIRING”
“PIN IS 0000”: Enter “0000” on
the Bluetooth device.
(C) “PAIRING”: Operate the Bluetooth device to
confirm pairing.
After pairing is successful, “PAIRING OK”
“[Device
Name]” appears and Bluetooth compatibility check
starts.
If “CONNECT NOW USING PHONE” appears, operate
the Bluetooth device to allow phonebook access to
continue.
The connectivity result flashes on the display.
“PAIRING OK” and/or “H.FREE OK”*
1
and/or
“A.STREAM OK”*
2
and/or “PBAP OK”*
3
: Compatible
*
1
Compatible with Hands-Free Profile (HFP)
*
2
Compatible with Advanced Audio Distribution
Profile (A2DP)
*
3
Compatible with Phonebook Access profile
(PBAP)
After 30 seconds, “PAIRING DELETED” appears to
indicate that pairing has been deleted, and the unit
exits check mode.
• To cancel, press and hold B /SOURCE to turn off
the power, then turn on the power again.
JS_JVC_KD_R951BT_E_04_EN.indd 10JS_JVC_KD_R951BT_E_04_EN.indd 10 12/11/2013 4:01:48 PM12/11/2013 4:01:48 PM
Downloaded from www.vandenborre.be
To Next Page
Loading...
Need help?
General
