JVC KD-X320BT User Manual

ENGLISH
23
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
TROUBLESHOOTING
Symptom Remedy
iHeartRadio
“STATION NOT AVAILABLE” Broadcast from the station is over.
“STATION NOT SELECTED” No station is selected.
“STREAM ERR” Broadcast data is interrupted.
“THUMBS ERR” Registration of Thumbs Up/Down has failed.
“TIMED OUT” The request has resulted in time-out.
Bluetooth®
No Bluetooth device is
detected.
• Search from the Bluetooth device again.
• Reset the unit.
( 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to
both the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again.
( 11)
Echo or noise occurs. • Adjust the microphone unit’s position. ( 11)
• Check the [ECHO CANCEL] setting. ( 12)
Phone sound quality is
poor.
• Reduce the distance between the unit and the
Bluetooth device.
• Move the car to a place where you can get a better
signal reception.
Sound is being interrupted
or skipped during playback
of a Bluetooth audio
player.
• Reduce the distance between the unit and the
Bluetooth audio player.
• Turn off, then turn on the unit and try to connect
again.
• Other Bluetooth devices might be trying to connect to
the unit.
Symptom Remedy
Bluetooth®
The connected
Bluetooth audio player
cannot be controlled.
• Check whether the connected Bluetooth audio player
supports Audio/Video Remote Control Profile (AVRCP).
(Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
“PAIRING FULL” The number of registered devices has reached its limit.
Retry after deleting an unnecessary device.
( 15,
DELETE PAIR)
“PLEASE WAIT” The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the unit,
then connect the device again.
“BT DEVICE NOT
FOUND”
The unit failed to search for the registered Bluetooth
devices during
[AUTO CNNCT] . Turn on Bluetooth from
your device and connect manually.
( 15)
“NOT SUPPORT” The connected phone does not support Voice Recognition
feature.
“ERROR” Try the operation again. If “ERROR” appears again, check if
the device supports the function you have tried.
“H/W ERROR” Reset the unit and try the operation again. If “H/W ERROR”
appears again, consult your nearest service center.
“BT ERROR PLS
UPDATE”
Update the Bluetooth firmware.
( 4)
If you still have troubles, reset the unit. ( 3)
JS_JVC_KD_X320BT_U_EN_00_2.indd 23JS_JVC_KD_X320BT_U_EN_00_2.indd 23 11/9/2014 4:52:54 PM11/9/2014 4:52:54 PM

JVC KD-X320BT Specifications

General

Brand	JVC
Model	KD-X320BT
Category	Receiver
Language	English