To Previous Page

(Part 2)

Your TV is Smart capable, and, by connecting it to internet, you can access to the APPs.

Your TV is internet-ready, and can be connected to your home network in two ways, by the wired connection

or by the wireless connection.

Connecting to a wired network

1. Ensure you have;

- An Ethernet cable long enough to reach to your TV.

- A router or modem with an available Ethernet port.

- A high-speed internet connection

2. Connect your Ethemet cable to the router or the

modem and to the Ethernet port on the back of your TV.

3. Use the Network menu to configure the TV.

Connecting to a wireless network

1. Ensure you have;

- A router broadcasting a high-speed wireless

signal.

- A high speed internet connection.

2. Use the Network menu to configure the TV.

Network Menu: Refer to the supplied user manual.

mode.

Antenna/Cable

ANTENNA

A) Connect the power cord plug to the power outlet on your wall.

B) The power indicator on the front of the TV will light up red.

JVC SERVICE & TECHNICAL SUPPORT

www.jvcproducts.com

This product is manufactured, distributed, serviced and warranted exclusively by E & S International

Enterprises, Inc. “JVC” is the trademark of JVCKENWOOD Corporation, used by such company under license.

LT-32EC3208

Initial setup involves selecting all the settings required to be able to search for and store all the channels

you can receive. Make sure that the television is switched on and follow all the steps in turn specified

hereafter. The first time you switch the set on,the initial setup menu appears, which guides you through the initial

setup process. Press ok to enter.

Step 1: Environment

Step 2: Were are you?

Step 3:

Terms & Conditions

Press ▲/▼ to select your environment.Then press OK to enter next step.

Press ▲/▼ to select your Country/Region.Press OK to comfirm and move to next step.

Use ▲/▼ to read Terms & Conditions,then press OK to comfirm and move to next step.

Step 4: Channel installation

Press ▲/▼ to select Continue to install channels.

Follow the guides on the screen and press the corresponding buttons on the remote control to proceed

Step 5: Please check settings

When all setup is done，press OK to finish the initial setup.

You can also go back to former step and make any changes .