JVC RM-RK50 User Manual

KD-G464
Installation/Connection Manual
GET0302-002A
[UI]
1204DTSMDTJEIN
EN
This receiver is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC
car audio dealers.
J
Handles
F
Washer (ø5)
G
Lock nut (M5)
H
Mounting bolt (M5 x 20 mm)
I
Rubber cushion
A / B
Hard case/Control panel
D
Tr im plate
E
Power cord
Parts list for installation and connection
The following parts are provided for this receiver.
After checking them, please set them correctly.
1
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this receiver correctly, have it installed by a qualifi ed technician.
Do the required electrical connections.
*
1
When you stand the receiver, be
careful not to damage the fuse on
the rear.
Bend the appropriate tabs to hold
the sleeve fi rmly in place.
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
• Receiver becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• This receiver does not work at all.
* Have you reset your receiver?
C
Sleeve
K
Battery
L
Remote controller
Removing the receiver
Before removing the receiver, release the rear section.
Insert the two handles,
then pull them as illustrated
so that the receiver can be
removed.
When installing the receiver without using the sleeve
In a Toyota for example, fi rst remove the car radio and install the receiver in its
place.
When using the optional stay
Note : When installing the receiver on the mounting bracket, make sure
to use the 8 mm-long screws. If longer screws are used, they could
damage the receiver.
Bracket*
Bracket*
* Not included for this receiver.
Flat type screws
(M5 x 8 mm)*
Pocket
Flat type screws
(M5 x 8 mm)*
Screw (option)
Stay (option)
Fire wall
Dashboard
Install the receiver at an
angle of less than 30˚.
PRECAUTIONS on power supply and speaker connections:
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the receiver will be seriously
damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.
RM-RK50
Instal1-2_KD-G464_002A_1.indd 1Instal1-2_KD-G464_002A_1.indd 1 12/22/04 11:35:47 PM12/22/04 11:35:47 PM

JVC RM-RK50 Specifications

General

Brand	JVC
Model	RM-RK50
Category	Car Receiver
Language	English