1-2 (No.MB428)
SPECIFICATION
Center unit (XV-THC9/XV-THC6/XV-THC3)
*1: This value is measured at System cord CONNECTOR for reference.
*2: Corresponding to Linear PCM, Dolby Digital, and DTS Digital Surround (with sampling frequency -32 kHz, 44.1 kHz, 48 kHz)
Subwoofer (SP-PWC6/SP-PWC3)
Audio section Total Harmonic Distortion *1 0.02%
Digital input*2 DIGITAL IN (DBS)
(OPTICAL)
-21 dBm to -15 dBm
(660 nm ± 30 nm)
Video section Video System PAL/NTSC
Horizontal Resolution 500 lines
Signal-to-Noise Ratio 64 dB
Video output level Composite: 1.0 V(p-p)/75 Ω
S-video-Y: 1.0 V(p-p)/75 Ω
S-video-C: For PAL: 0.3 V(p-p)/75 Ω
S-video-C: For NTSC: 0.286 V(p-p)/75 Ω
Component-Y: 1.0 V(p-p)/75 Ω
Component-PB/PR: 0.7 V(p-p)/75 Ω
Video input sensitivity/Impedance (VCR IN) Composite: 1.0 V(p-p)/75 Ω
S-video-Y: 1.0 V(p-p)/75 Ω
S-video-C: For PAL: 0.3 V(p-p)/75 Ω
S-video-C: For NTSC: 0.286 V(p-p)/75 Ω
Tuner section Tuning Range FM 87.5 MHz to 108.0 MHz
AM (Except for Middle East) 531 kHz to 1 710 kHz (at 9 kHz channel spacing)
530 kHz to 1 710 kHz (at 10 kHz channel spacing)
AM (For Middle East) 531 kHz to 1 602 kHz (at 9 kHz channel spacing)
530 kHz to 1 600 kHz (at 10 kHz channel spacing)
General Power Requirements AC 110-240 V , 50/60 Hz
Power Consumption 19 W (at operation)
1.9 W (in standby mode)
Dimensions (W × H × D) 400 mm × 85 mm × 399 mm
Mass 4.2 kg
Amplifier section Front 140W per channel, RMS at 4 Ω at 1 kHz, with 10% total harmonic dis-
tortion.
Center/Surround 130W per channel, RMS at 4 Ω at 1 kHz, with 10% total harmonic dis-
tortion.
Subwoofer 140 W, RMS at 4 Ω at 100 Hz, with 10% total harmonic distortion.
Speaker section Speaker unit 16 cm Bass-reflex
Power Handling Capacity 140 W
Impedance 4 Ω
Frequency Range 30 Hz to 200 Hz
General Power Requirements Except for Australia AC 110 V/ AC 127 V/AC 220-240 V , 50/60 Hz
For Australia only AC 240 V , 50 Hz
Power Consumption 135 W (at operation)
0 W (in standby mode)
Dimensions (W × H × D) 169 mm × 411 mm × 459 mm
Mass 11.3 kg
To Next Page
Loading...
Need help?
General
