JVC UX-C7 User Manual

UX-C7 B/E/G/GI/EN
@ Inportant management points regarding safety(Item demanding special safety precautions)
1. Power transformer marking :VTP66T4 — 24B(B version:Parts No.), VIP66J4 — 24B( E/G/GI/EN Version : Parts No.)
The torque of the screw driver for the poewr transformor must be controlled.
2. Following parts are controlled as the heated parts. confirm that the flammable parts are lifted up the parts in.
*Diode:D901~D905, IC: ICA35, Transistor:QA306 ,Power transformer
3. Concerning the AC socket, the next marking must be confirmed and to avoid print circuit board pattern damage.
The AC socket must not float from print circuit board.
SMaLking vorceseserecsressersteceeeeereeteeeeeeeeeeeeees HSC1466
4. Concerning the primary terminal and the adjacent secondary terminal on the print circuit board toprovide proper
creeping and spatial distance, solder must not protrude from soldering round.
5. Before installation confirm the fuse capacity indication, ( 9 Jand ((S))marks on the fuse holder.
6. Confirm following “Electromagnetic compatibility” control matter.
* Main P.C. board
C901~C908, CA123, CA223, RA141, RA241, LA101, LA201, LA102, LA202, RA108,RA208, CA113, CA213,
CA102, CA202, LD901, LD902, LA103, LA203
* Tuner P.C. board
C14, C55, L16, L17, Shield case & shield(VMA4554 — 002, VMA4531 — 002, VMA4522 - 003, VMA4521 — 002,
VMA4561 — 002), QWY122 ~ 040, BP1,Shield case & shield(VMW240 — O5NTA4,VMA4617 — 001, VMA4562 —
001)
7. Wires must be clamped or sccured at the locations shown in the figure so that the wire do not touch to live parts,
moving part , hot part, or sharp edges.
Power
amplifier
P.C. board
CA316
CA317
Ref. No. 7: Wires must be clamped.
( Except UX — C7G/GI )
4 (No. 1898)

JVC UX-C7 Specifications

General

Brand	JVC
Model	UX-C7
Category	Stereo System
Language	English