K 2801 / K 2801 plus
14
English
Eliminating faults yourself
You can eliminate minor faults yourself using the following overview. In case of doubt, or if you encounter
a fault or cause not listed here, please consult an authorized Customer Service point.
Danger of electric shock!
Repair work on the machine may only be carried out by the authorized Customer Service.
Fault Cause Remedy
Vacuum cleaner does
not start.
No mains power. Check fuse, cable, plug and socket
and, if required, have them replaced
by an electrician.
Suction power
decreases.
Paper filter bag, flat pleated filter,
nozzle, suction hose or suction tube
blocked. Filter status display lit red.
Check and, if required, clean.
Paper filter bag or dirt container full. Replace paper filter bag or empty dirt
container.
No flat pleated filter or incorrectly
inserted.
Insert flat pleated filter correctly.
Dust escapes when
vacuuming.
Suction hose incorrectly connected. Connect suction hose correctly.
No flat pleated filter, incorrectly
inserted or defective.
Insert flat pleated filter correctly or
replace.
When wet-vacuuming:
water or foam leaks
out.
Float jammed.
Float switch defective.
Switch off the appliance immediately.
Remove and turn over motor housing.
Release the jammed float in the cage.
If the fault cannot be eliminated,
please consult customer service
Technical Specifications
Mains connection
(EU 220–230 V) (GB: 220–240 V) (AUS: 240 V)
1~50/60 Hz
Fuse protection (surge-proof) 10 A
Power (suction motor) P
max
1400 Watt
P
nom
1200 Watt
Air flow rate 78 l/s
Vacuum 220 mbar
Capacity 25 l
Max. water capacity 18 l
Length 390 mm
Width 290 mm
Height 570 mm
Weight without accessories 7 kg
Nominal width, accessory Ø 35 + 60 mm
Sound level 72 dB(A)
Class of protection II
Cable length 5.7 m
Circuit diagram
M1 Suction turbine
S1 Vacuum motor switch
X1 Plug
C1 Interference suppressor
Declaration of Conformity
Documentation concerning the CE
declaration can be requested from the
manufacturer.
To Next Page
Loading...
Need help?
General
