12
4.1 High Pressure Operation
• Switch on the pressure washer (No.4)
• Ensure the Spray Lance with the Pressure Regulator (No.16) is attached
securely to the Spray Gun (No.12) and the nozzle is set to the required
setting (+).
• Aim the lance towards the object to be cleaned making sure the
recommended working distance is used (for reference see Page 11).
Release the Safety Lock Device (No.13) on the Spray Gun and
squeeze the lever.
The pressurised water jet alone is capable of fulfiling most
cleaning tasks around the garden or on building work but
detergent and wash brush are advantageous when cleaning
vehicles or other paint finishes.
4.2 Adding detergent
There are two possibilities:
A – Detergent with high-pressure
• Fit the detergent chamber with a
Clean Stick.
• Set the metering of the detergent.
• Switch on the pressure washer (No. 4)
• Aim the Spray Gun towards the object to be cleaned, release the
Safety Ratchet on the Spray Gun and squeeze the trigger to apply
the detergent to the working area.
After use of detergent:
• Remove remaining Clean Stick from the detergent chamber; allow to
dry; store for subsequent use.
B – Detergent with low-pressure
• Fill the Detergent Tank (No.11) with the selected detergent, ensuring
it is the correct concentration (See Page 8 or read recommended do-
sage on label. The correct dilution is dependent on the degree of soi-
ling of surface and is best determined by experience.)
• Set the Spray Lance (No.16) to the lowest working pressure setting "–".
To Next Page
Loading...
Need help?
General
