Kärcher HDS 8/18-4 C User Manual

– 8
 Set dosing value for detergent to "0".
 Set the appliance switch to "1" (opera-
tion with cold water).
 Open the hand spray gun and rinse the
appliance for at least 1 minute.
 DANGER
Danger of scalding from hot water! After the
operation with hot water or steam, the de-
vice must be operated with opened gun
with cold water for at least two minutes.
 Shut off water supply.
 Open the hand spray gun.
 Switch on the pump with the power
switch and allow to run for about 5-10
seconds.
 Close the hand spray gun.
 Set the appliance switch to "0/OFF“.
 Pull main plug out of socket with dry
hands only.
 Remove water connection.
 Activate hand spray gun until device is
pressure less.
 Secure the trigger gun. To do so, push
the safety catch towards the front.
 Lock in the steel pipe into the holder of
the appliance hood.
 Roll up high pressure hose and electri-
cal conduit and hang them into the re-
spective holders.
Note: Do not twist high pressure hose and
electrical conduit.
ATTENTION
Risk of damage! Frost will destroy the appli-
ance if the water has not been completely
drained.
 Store in a frost free area.
If the device is connected to a chimney, the
following must be observed:
ATTENTION
Threat of damage by penetrating cold air
through the chimney.
 Disconnect device from chimney when
outside temperature drops below 0 °C.
If it is not possible to store frost free, shut
down device.
For longer work breaks or if a frost free stor-
age is not possible:
 Empty detergent tank.
 Drain water.
 Flush device with anti-freeze agent.
 Screw off water supply hose and high
pressure hose.
 Screw off supply hose at boiler bottom
and drain heating spiral empty.
 Operate device for max. 1 minute until
the pump and conduits are empty.
Note: Observe handling instructions of the
anti-freeze agent manufacturer.
 Fill anti-freeze agent of the trade into
swimmer container.
 Switch on appliance (without heater) till
the appliance has been completely
rinsed.
A certain corrosion protection is achieved
with this as well.
몇 CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.
Figure 10
ATTENTION
Risk of damage! When loading the appli-
ance with a forklift, observe the illustration.
ATTENTION
Protect the trigger from damage during
transport.
After operation with detergent
Turn off the appliance
Storing the Appliance
Frost protection
Shutdown
Dump water
Flush device with anti-freeze agent
Storage
Transport
30 EN

Kärcher HDS 8/18-4 C Specifications

General

Cable length	5 m
Fuel tank capacity	15 L
Connected load	6000 W
AC input voltage	400 V
Number of phases	3
AC input frequency	50 Hz
Working pressure (max)	180 bar
Working pressure (min)	30 bar
Heating oil/gas consumption (full load)	5 kg/h

Weight and Dimensions

Depth	650 mm
Width	1060 mm
Height	920 mm
Weight	112000 g