Kärcher SBP 2200 User Manual (English)

Questions and Answers:

S
sandra66Jul 25, 2025
What to do if Kärcher Power Pump does not run?
- A
  Angela MillerJul 25, 2025
  If your Kärcher Power Pump stops running or suddenly comes to a standstill, several factors could be at play. First, check the fuses and electrical connections to ensure the power supply hasn't been interrupted. The thermal protection switch in the motor might have switched off the pump due to overheating; if this is the case, pull out the mains plug, let the pump cool down, clean the suction area, and prevent dry running. Also, dirt particles may have jammed the suction area, so pull out the mains plug and clean it. Finally, the pump operation might have been stopped by a sensor, so verify the level sensor's position.
C
Christopher MataAug 1, 2025
How to fix Kärcher Power Pump that runs but does not pump water?
- T
  Tonya NelsonAug 1, 2025
  If your Kärcher Power Pump runs but doesn't transport water, it could be due to several reasons. Air might be trapped in the pump; try plugging in and pulling out the mains plug a few times until the fluid gets sucked in. Alternatively, the suction area might be blocked, so pull out the mains plug and clean it. If operating in manual mode, ensure the water level is above the minimum; immerse the pump deeper if possible or follow the instructions for automatic operation. A blocked pressure hose could also be the culprit; pull out the mains plug and clean the pressure hose. Finally, check that the locking tap is open (arrow vertical).
R
Richard FernandezAug 8, 2025
Why is the pumping capacity too low on my Kärcher Power Pump?
- A
  Andrew ToddAug 9, 2025
  If your Kärcher Power Pump's pumping capacity is too low, remember that the pumping capacity depends on the flow height, hose diameter, and hose length. Keep the flow height within the maximum specified in the technical data. If necessary, select a different hose diameter or hose length to improve performance.
S
Sandra PierceAug 17, 2025
What to do if Kärcher Power Pump pumping capacity is reducing?
- S
  Stephen MorganAug 17, 2025
  If the pumping capacity of your Kärcher Power Pump is reducing, it might be because the suction area is blocked. To resolve this, pull out the mains plug and clean the suction area.