f
®
FOOD WASTE DISPOSERS
Installation, Care & Use Manual
TOOLS AND MATERIALS YOU WILL NEED:
Slotted Screwdriver, Adjustable Pliers, Plumber's Putty,
Electrical Tape
TOOLS, MATERIALS, AND ACCESSORIES
YOU MAY NEED:
Phillips Screwdriver, Drain Auger, 3/8" Electrical Clamp
Connector, Wire Nuts (2), Second 1 1/2" Drain Trap,
Hammer, Hacksaw, Water Hose Clamp, Pipe Wrench,
Copper Ground Wire, Dishwasher Drain Connection Kit, Air
Gap, Electrical On/Off Switch, Drain Tube Extension
Read through the entire Installation, Care
& Use manual before installing the dis-
poser. Determine which of the tools,
materials, and accessories you will need
before you begin. Make sure you have all
necessary disposer parts before install-
ing the disposer (see part identification
diagram below).
(_/A
JlB
O--c
O--G
Mounting Assembly
A: Stopper
B: Sink Flange
C: Fiber Gasket
D: Backup Ring
E: Mounting Ring
F: Screws (3)
G: Snap Ring
Disposer
H: Mounting Gasket/Splash Baffle
1: Lower Mounting Ring
J: Dishwasher Inlet
K: Discharge Outlet
L: Wrenchette
_ @-N
#1 .-0
OR
--#2 ___N
Two-Bolt Discharge
N: Bolt (2)
_10: DischargeTube (1-1/2" Diam.)
P: Flange
Q: Gasket
OR
One-Bolt Discharge
N: Bolt
#20:DischargeTube(1-1/2" Diam.)
P: Flange
Q: Gasket
SAFETY SYMBOLS
Danger indicates an
imminently hazardous situation which,
if not avoided, will result in death or
serious injury.
It" WARNINGIWarning indicates
a potentially hazardous situation
which, if not avoided, could result in
death or serious injury.
[_kCAUTION] Caution indicates a
potentially hazardous situation which,
if not avoided, may result in minor or
moderate injury,
To Next Page
Need help?
General
