Kenwood BM250 User Manual

10
troubleshooting guide (continued)
PROBLEM POSSIBLE CAUSE SOLUTION
15. Kneader cannot
be removed.
16. Bread sticks to pan/
difficult to shake out.
17. Breadmaker not
operating/Kneader not
moving.
18. Ingredients not mixed.
19. Burning odour noted
during operation.
20. Machine unplugged
by mistake or power
lost during use.
How can I save
the bread?.
21. E:01 appears on
display and machine
cannot be turned on.
22. H:HH & E:EE
appears in display and
machine does not operate.
•You must add water to bread pan and
allow kneader to soak before it can
be removed.
• Can happen over prolonged use.
•Breadmaker not switched on
• Pan not correctly located.
• Delay timer selected.
• Did not start bread maker.
• Forgot to put kneader in pan.
• Ingredients spilled inside oven.
• Pan leaks.
•Exceeding capacity of bread pan.
• Oven chamber too hot.
•Bread machine is malfunctioning.
Temperature sensor error
• Follow cleaning instructions after use.
You may need to twist kneader slightly
after soaking to loosen.
• Lightly wipe the inside of bread pan
with vegetable oil.
• Refer to “Service and customer care”
section.
• Check on/off switch 햹 is in the ON position.
• Check the pan is locked in place.
•Breadmaker will not start until the
countdown reaches the program start
time.
• After programming control panel, press
start button to turn bread maker on.
• Always make sure kneader is on shaft
in bottom of pan before adding
ingredients.
• Be careful not to spill ingredients when
adding to pan. Ingredients can burn on
heating unit and cause smoke.
• See “Service and Customer care”
section.
• Do not use more ingredients than
recommended in recipe and always
measure ingredients accurately.
• Unplug and allow to cool down for 30
minutes.
• See “Service and Customer care”
section.
PAN PROBLEMS
MACHINE MECHANICS
• If machine is in knead cycle, discard ingredients and start again.
• If machine is in rise cycle, remove dough from bread pan, shape and place in
greased 23 x 12.5cm/9 x 5 in. loaf tin, cover and allow to rise until doubled in size.
Use bake only setting 11 or bake in pre-heated conventional oven at
200ºC/400ºF/Gas mark 6 for 30-35 minutes or until golden brown.
• If machine is in bake cycle, use the bake only setting 11 or bake in pre-heated
conventional oven at 200ºC/400ºF/Gas mark 6 and remove top rack. Carefully
remove pan from machine and place on bottom rack in oven. Bake until golden brown.

Kenwood BM250 Specifications

General

Display type	LCD
Product color	White
Delayed start timer	Yes
Auto programs quantity	12
Dimensions (WxDxH)	345 x 250 x 310 mm

Weight and Dimensions

Depth	250 mm
Width	345 mm
Height	310 mm
Weight	6300 g