Kenwood KX-W1060 User Manual

Before applying power
/\\ caution : Read this page carefully to ensure safe operation.
For the U.S.A., Mexico and Canada
Important!
Units shipped to the U.S.A., Mexico and Canada are designed
for operation on 120 volts AC only.
For the United Kingdom
Important!
Units shipped to the U.K. are designed for operation on 240
volts AC only.
Factory fitted moulded mains plug
1. The mains plug contains a fuse. For replacement, use only a 3-Amp
ASTA-approved (BS1362) fuse.
2. The fuse cover must be refitted when replacing the fuse in the
moulded plug.
3. Do not cut off the mains plug from this equipment. If the plug fitted
is not suitable for the power points in your home or the cable is too
short to reach a power point, then obtain an appropriate safety
approved extension lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and
dispose of the plug immediately, to avoid a possible shock hazard
by inadvertent connection to the mains supply.
Safety precautions
For Australia and Europe
Important!
Units shipped to Australia are designed for operation on 240 Volts
AC only.
Units shipped to Europe are designed for operation on 230 Volts AC
only.
For other countries
Important!
Units shipped to countries other than the above countries are equipped
with an AC voltage selector switch on the rear panel. Refer to the
following paragraph for the proper setting of this switch.
AC voltage selection
This unit operates on 110 - 120 volts or 220 - 240 volts AC. The AC
voltage selector switch on the rear panel is set to the voltage that
prevails in the area to which the unit is shipped. Before connecting
the power cord to your AC outlet, make sure that the setting position
of this switch matches your line voltage. If not, it must be set to your
voltage in accordance with the following direction.
AC voltage selector switch
AC110-120V~ ~= m AC220-240V~
Cm
Move switch lever to match your line voltage with
a small screwdriver or other pointed tool.
Note: ———__—______——
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector switch.
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SER-
VICING TO QUALIFIED SERVICE PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE,
IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOL-
TAGE” WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE
TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE
USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) IN-
STRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.
KX-W1060/KX-W594 (En) 3

Kenwood KX-W1060 Specifications

General

Brand	Kenwood
Model	KX-W1060
Category	Tape Deck
Language	English