To Next Page

To Previous Page

5.2 - Commissioning

Following the successful testing of all (and not just some) devices in

the system you can proceed with the commissioning.

You must prepare, and keep for 10 years, the technical le of the

system with the wiring diagram, drawing or photo of the system,

risks analysis and solutions adopted, manufacturer declaration of

conformity of all devices connected, instruction manual of each de-

vice and maintenance schedule of the system.

Fix on the gate or door a plaque indicating the automation data, the

name of the person responsible for the commissioning, the serial

number and year of construction, the CE mark.

Attach a plaque indicating the steps required to manually unlock

the system.

Implement and deliver to the end user the declaration of conform-

ity, the instructions and warnings for use for the end user and the

maintenance schedule of the system.

Make sure the user understands proper automatic, manual and

emergency operation of the automation.

Inform the end user in writing of the dangers and risks still present.

5.1 - Testing

All system components must be tested following the procedures

outlined in the respective instruction manuals.

Check that they meet the guidelines in Chapter 1 - Safety warnings

Check that the gate or door can move freely once the automation

is unlocked, and that they are in equilibrium and stationary if left in

any position.

Check the correct operation of all connected devices (photocells,

sensitive edges, emergency buttons, etc.), testing the opening,

closing and stopping of the gate or door via the connected control

devices (transmitters, buttons, switches).

Carry out measurements of the impact force, as prescribed by

standard EN12445 adjusting the functions of speed, motor force

and deceleration of the unit if the measurements do not give the

desired results until you nd the right setting.

The testing of the system must be performed by qualied techni-

cians who must perform the tests required by relevant legislation

related to risks, ensuring compliance with the provisions of the

regulations, in particular the EN12445 standard, which species the

testing methods for the automation of doors and gates.

5 - TESTING AND COMMISSIONING THE AUTOMATION SYSTEM

Key Automation Sun User Manual

Questions and Answers: