14
NOTE: If no further steps are taken within 15 minutes of initial power up, a voice prompt, “No devices found, not
connected” will be heard once, and the wireless function will turn off. The unit will then perform as a standard
hardwired alarm. See Section 9.3 for re-activating wireless.
C. PICK ONE DEVICE
Press and hold the button on only ONE device until you hear two beeps.
Release button. You will hear “Searching for other devices”.
• The light will pulse and device will sound a continuous “Sonar” ping until
step E is complete.
D. RELAX AND WAIT
Wait until all devices have connected to network. Once connected, each
device will speak, “Success now connected!”
• Once connected, the lights will glow green.
E. PICK ONE DEVICE
Press and hold the button on only ONE device until you hear 2 beeps.
Release button. “Sonar” ping will stop.
• Device will announce that setup is complete and the number of connect-
ed devices.
F. SETUP COMPLETE!
If all devices flash green and “Sonar” ping has stopped, the devices are now connected. Congratulations!
G. PROCEED TO WIRING INSTRUCTIONS IN SECTION 10.
Figure 9.1-C
DON'T press buttons
on other devices
other devices.”
Hold for
5 seconds
Figure 9.1-D
“Success, now
connected!”
Figure 9.1-E
Hold for
5 seconds
To Next Page
Loading...
Need help?
General
