EasyManuals Logo
Home>KMART>Water Filtration Systems>Pitcher

KMART Pitcher User Manual

KMART Pitcher
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
4. Replace the Reservoir into the Pitcher. The tallest part of the Reservoir must
face the front of the Pitcher.
5. Prepare and Install the Filter:
**Use cold or room temperature water.
a. Wash your hands and then remove the Filter from its package. Soak it
upright in water for 10 minutes.
b. Rinse the Filter under running water for 10 seconds.
c. Press it firmly down into the tube of the Reservoir to ensure a tight seal.
6. Attach the Lid.
7. Fill the Pitcher:
**Always use cold or room temperature water when filling the Pitcher.
Press down on the tab next to the Filter Life Indicator to open the hole in the
Lid. Fill the Reservoir with water and allow all the water to filter through.
Discard the water and repeat. The third pitcher of water is ready for drinking.
Always allow all the water in the Reservoir to pass through the Filter before
pouring the water.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KMART Pitcher and is the answer not in the manual?

KMART Pitcher Specifications

General IconGeneral
BrandKMART
ModelPitcher
CategoryWater Filtration Systems
LanguageEnglish