15
OPERATING INSTRUCTIONS
The battery will only be half charged when it is pur-
chased. Before using the chain saw for the rst time,
place the battery in the battery charger and charge it
fully. Be sure to read all safety precautions and follow
the instructions in the battery and charger manuals.
When storing the chain saw for a prolonged period of
time, remove the battery. When the chain saw is going
to be used again, charge the battery for at least a full
charging period. The battery has no memory effect.
Battery
• Align the battery (M) with the battery opening.
• Insert the battery into the battery opening until the
battery release button (N) locks into place.
• Push down on the battery until it locks into place.
You should hear a “click” once it is installed.
To install the battery:
WARNING
Follow these instructions on order to avoid injury and to reduce the risk of electric shock or re:
• Replace the battery or the charger immediately if the battery case or charger cord is damaged.
• Verify that the battery is removed before inspecting, adjusting, or performing maintenance on any
part of the chain saw.
• Read, understand, and follow the instructions contained in the charger manual.
M
N
• Press the battery release button (N) on the chain
saw. This will cause the battery to raise out of the
tool slightly.
• Grasp the chain saw rmly and pull the battery out
of the battery opening.
To remove the battery:
IMPORTANT
This Lithium-ion battery is equipped with an internal protection, which will automatically shut off the
power to the tool and then reset itself once cooled. Follow these steps if an overload occurs while
under heavy use:
• Release the power switch and restart tool by depressing switch.
• The battery may need to be removed for approximately 1 minute, allowed to cool and then rein-
stalled for use.
To Next Page
Loading...
Need help?
General
