7
kobalttools.com
ASSEMBLY INSTRUCTIONS
High Pressure Hose Assembly
4. Connect the other end of high pressure hose (B)
to spray gun (I) by screwing collar over gun inlet.
Hand tighten (turning clockwise) until tight. Hose
is now securely attached to the spray gun.
Note: High pressure hose (B) is tted to the hose
reel and ready to use. It only needs to be at-
tached to the spray gun (I).
5. To release the hose (B) from spray gun (I), turn
black collar counterclockwise. Remove gun.
4
B
I
3. Slip tab of stabilizer foot (E) into slot on bottom
portion of power unit (A). Secure with screw (AA).
3
E
AA
A
5
B
I
Hardware Used
Screw
x 1
AA
To Next Page
Loading...
Need help?
General
