Troubleshooting (cont.)
Cleansing Features
Symptoms Probable Causes Recommended Action
C. The Ground-Fault
Circuit-Interrupter
(GFCI) or Residual
Current Device
(RCD) is tripped.
C. Reset the GFCI or
RCD.
D. The user is not
detected by the
seat sensor.
D1. Small children may
be too light to be
detected by the
sensor.
D2. Shift your position
on the seat. The
sensor is located on
the front of the seat.
2. The seat is
loose.
A. The mounting
plate fasteners are
loose.
A. Tighten the fasteners.
Refer to the
Installation Guide.
3. Water stops
flowing from
the spray
wand before
cleansing is
complete.
A. Washing
automatically stops
1 minute after
pressing a spray
icon.
A. Press the ″Front″ or
″Rear″ icon to restart
cleansing.
B. The user shifted
position and is no
longer detected by
the seat sensor.
B. Shift your position
on the seat. The
sensor is located on
the front of the seat.
Remote Control Compliance
FCC ID: N82-KOHLER024, N82-KOHLER025
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
1381632-5-A 16 Kohler Co.
To Next Page
Loading...
Need help?
General
