635 mm
Mira Beat Shower Fittings
Installation & User Guide
These instructions must be left with the user
0844 571 5000
To Contact Us: UK
Calls cost 7p per minute plus your phone
company’s access charge
www.mirashowers.co.uk - Full details of
the manufacturer’s guarantee is available
on the website.
Spare Parts
Cleaning and User Maintenance
De-scaling the Showerhead
Important! Keeping the showerhead clean and
free from limescale will ensure that your shower
and showerhead continue to perform to their
maximum. A blocked showerhead can restrict the
ow rate and may cause damage to your shower.
6 7
1740.616 (Multi Mode - White)
1740.615 (Multi Mode - Chrome)
Handset Assembly
632.73
Hose Seal (x2)
1703.202 (White)
1703.203 (Chrome)
Clamp Bracket
Assembly
1703.210
Shower Hose (1.25 m)
1603.104
Shower Hose (Metal)
1603.137
Shower Hose (Plastic)
1703.195
Taper Block
1264164
Slide Bar
1703.194
Mounting Pack
1740.595 (White)
1740.596 (Chrome)
Slide Bar Support (x2)
Use your thumb or a
soft cloth to wipe any
limescale from the
nozzles
1703.197
Soap Dish
1703.196
Cap (x2)
Operation
Clamp Bracket Adjustment
1. Slide the Clamp Bracket up and down on the
Slide Rail until the Showerhead is positioned to
your preference.
Handset Installation
Handset
Assembly
Hose and Handset Installation
1. Fit a hose seal into the conical nut and screw
onto the outlet of the shower.
Caution! Do not over tighten.
2. Feed the hose through the soap dish.
3. Fit a hose seal into the conical nut and screw
onto the handset assembly.
Caution! Do not over tighten.
4. Place the handset assembly into the clamp
bracket assembly.
1. Unscrew the hose
from the showerhead
and the shower outlet.
2. Inspect the hose.
3. Replace if necessary.
Inspecting the Hose
Important! The shower hose should be inspected
periodically for damage or internal collapse,
internal collapse can restrict the ow rate from the
showerhead and may cause damage to the shower.
1740.368 (Multi Mode - White)
1740.369 (Multi Mode - Chrome)
Handset Assembly
To Next Page
Need help?
General
