5
Setting Up the Printer Driver
5-16 C350
5.9 Hole Punching Documents
✎
Note
The hole punch function is available only when optional finisher FS-
601 is installed on this machine.
Setting procedure
1 Click the “Setup” tab.
2 Click the [Detail of Output Setting] button to display the detailed
settings dialog box.
3 From the Punch and Punch Holes drop-down lists, select one of the
following settings.
❍ Punch: “OFF”, “Top Side Punch”, “Left Side Punch”, or “Auto
Punch”
❍ Punch Holes: “2”, “3”, or “4”
✎
Note
When using the hole punch function, always select “2” or “3” from the
Punch Holes drop-down list.
No holes will be punched if “4” is selected.
To Next Page
Loading...
Need help?
General
