Koolatron Bite Shield Guardian MK-12 User Manual

ATTACHING THE PROPANE TANK
Step 1: Attach the power adapter
Socket
“On/Off” Switch
7
ASSEMBLY (Cont...)
Place a full tank (20lb) of propane on the base as shown.
Step 5: Install the Mosquito Receptacle to the Trap.
A) Install the receptacle tabs into the slots at the bottom surface of
the trap as shown.
B) Twist the Receptacle counterclock-wise to secure it to the trap.
Make sure the snap is well fit and both legs are inside the trap to
ensure all the mosquitoes trapped remain inside.
Step 4: Place the Propane Tank on the base.
Do not use a Propane Tank larger than 9.07 kg/20lb.
! WARNING: Follow the safety information listed on the tank.
A. Hang the power adapter on the back of the base as shown.
B. Plug the adapter end into the socket on the underside of the trap
body as shown.
Step 2: Place the Propane Tank on the Base. Do not use a Propane
Tank larger than 9.07kg (20 lb).
- Place a full tank of propane on the base. Follow the safety
information listed on the tank.
6
ASSEMBLY
Step 1: Assemble the support column to the base
Step 2: Attach the Burner Unit to the top of
the support column.
A - Place the base on a flat surface. Insert the support
column with the slotted side down as shown.
Press in firmly.
B - Flip the base upside down. At the underside of the
base, you would see a circular projection with 4 holes.
Make sure that the pole is inserted all the way down
into this projection such that the edges of the slotted
side are visible through the holes. Remove the wavy
hairpin from the locking pin and insert the latter
through the 4 holes. Insert the hairpin through the
hole at the end of the locking pin. This will ensure
that the pole is fully locked in place.
Attach the burner unit to the top of the support column as
shown. Press the tabs on the sides of the support column to
insert it into the hole in the burner unit.
Make sure that BOTH tabs pop up through the holes
in the bottom of the burner unit.
Step 3: Attach the power adapter.
A. Position the power adapter nearby the unit. Preferably
on top of the base.
B. Plug the adapter end into the socket on the underside
of the trap body as shown.

Koolatron Bite Shield Guardian MK-12 Specifications

General

Brand	Koolatron
Model	Bite Shield Guardian MK-12
Category	Lawn and Garden Equipment
Language	English