Install VM-1H4C using one of the following methods:
• Attach the rubber feet and place the unit on a flat surface.
• Fasten a bracket (included) on each side of the unit and attach it to a flat surface
(see www.kramerav.com/downloads/VM-1H4C).
• Mount the unit in a rack using the recommended rack adapter
(see www.kramerav.com/product/VM-1H4C).
• Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
• Avoid uneven mechanical loading.
• Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
• Reliable earthing of rack-mounted equipment should be maintained.
Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your VM-1H4C.
To achieve specified extension distances, use the recommended Kramer cables available at www.kramerav.com/product/VM-1H4C.
Using third-party cables may cause damage!
Step 5: Connect power
Connect the power cord to VM-1H4C and plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
• For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the
terminal or in the User Manual.
• There are no operator serviceable parts inside the unit.
Warning:
• Use only the power cord that is supplied with the unit.
• Disconnect the power and unplug the unit from the wall before installing.
1 HDMI connector
1 IR on a 3.5mm mini jack
1 RS-232 on a 9-pin D-sub connector
Supports up to 4.95Gbps (1.65Gbps per graphic channel)
COMPLIANCE WITH HDMI
STANDARD:
Power, INPUT, OUTPUT 1, 2, 3 and 4
0° to +40°C (32° to 104°F)
–40° to +70°C (–40° to 158°F)
10% to 90%, RHL non-condensing
21.5cm x 16.2cm x 4.4cm (8.5in x 6.38in x 1.7in) W, D, H
HDMI/HDMI male to male cables
Recommended rack adapter (see www.kramerav.com/product/VM-1H4C).
To Previous Page
Loading...
Need help?
General
