VM-2DH Quick Start Guide
This guide helps you install and use your VM-2DH for the first time.
Go to www.kramerav.com/downloads/VM-2DH to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VM-2DH DisplayPort to DVI/HDMI Converter
Step 2: Get to know your VM-2DH
Press to cycle through the EDID sources and to read the EDID (see Step 6)
Lights green when the input is active; flashes when the input is not valid
Lights green when a DVI acceptor output is connected
Lights green when an HDMI acceptor is connected
Lights green when the unit is powered on
DP IN DisplayPort Connector
Connect to the DisplayPort digital source
Connect to the DVI acceptor
Connect to the HDMI acceptor
Connect to the 5V DC power adapter, center pin positive
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Step 3: Mount VM-2DH
Install VM-2DH using one of the following methods:
• Attach the rubber feet and place the unit on a flat surface.
• Fasten a bracket (included) on each side of the unit and attach it to a flat surface
(see www.kramerav.com/downloads/VM-2DH).
• Mount the unit in a rack using the recommended rack adapter
(see www.kramerav.com/product/VM-2DH).
• Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
• Avoid uneven mechanical loading.
• Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
• Reliable earthing of rack-mounted equipment should be maintained.
To Next Page
Need help?
General
