Kramer VS-8UFX Quick Start Guide

VS-8UFX Quick Start (P/N: 2900-300846QS REV 1)
P/N:
2 9 0 0 - 3 0 0 8 4 6 Q S
Rev:
1
Scan for full manual
VS-8UFX Quick Start Guide
This guide helps you install and use your VS-8UFX for the first time.
Go to www.kramerav.com/downloads/VS-8UFX to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VS-8UFX Programmable 8 port 12G SDI Router
1 Set of rack ears
1 Quick start guide
1 Power cord
4 Rubber feet
Step 2: Get to know your VS-8UFX
#
Feature
Function
1
POWER LED
Illuminates when the device is powered.
2
PORT Buttons
Press an output port (lights green) and then an input port (lights blue) to route an input to an output.
3
CLEAR Button
Press to clear a selection.
4
TAKE Button
Press to enter Take mode.
In Take mode, press several sets of output-input ports and then press TAKE to activate all the selected
routings at the same time.
When Take mode is off, each output-input pair is switched immediately.
5
LOAD Button
To load a preset configuration:
Press LOAD, press the appropriate PORT preset button to select a preset configuration, and then press
TAKE to load that preset.
6
SAVE Button
To save the current port configuration to a PORT preset button:
Press SAVE, press the port button to which you want to save the configuration, and then press TAKE to
save the setup to that port.
7
INFO Button
Press to display general information, such as the firmware version and IP address.
Press INFO and then a specific PORT button to display the information of that selected port.
8
LCD Display Panel
Displays the current routing status, device information and so on.
9
LOCK Button
Press for 3 seconds (approx.) to lock the front panel buttons. When locked (button is lit), press again for 3
seconds (approx.) to unlock the front panel buttons.

Kramer VS-8UFX Specifications

General

Brand	Kramer
Model	VS-8UFX
Category	Network Router
Language	English