Krups XP5220 User Manual

English
9
Problems Possible causes Solutions
Water leaks under
the machine.
Internal leak.
Drip tray is not in the correct
position.
Drip tray has overflowed.
Check the position of the tank. If the fault persists,
do not use the machine, contact an approved
service centre.
Check that the drip tray is pushed completely into
the machine (see section 7).
Carefully empty and rinse the drip tray, then replace
in the machine (see Section 7).
Leaking filter holder.
The filter holder is not
properly positioned.
The edges of the filter holder
are clogged with excess
ground coffee.
Pod improperly positioned in
the filter.
Lock the filter holder firmly in place.
Take care when filling the filter to brush excess
coffee off the edges before locking the filter
holder in place.
Check that the pod is properly centered in the
filter, with excess paper removed from E.S.E.
pods, and that none of the paper is hanging over
the edges of the filter.
Your espresso tastes
bad.
After descaling, the rinsing
was not performed properly.
Rinse the machine carefully after descaling (see
Section 8).
The machine does
not work
The pump could not be
primed due to lack of water.
The water tank is not
properly positioned.
Fill the water tank and re-prime the pump (see
Section 4). Always check before starting a cycle
to see that there is sufficient water in the water
tank. Avoid allowing the tank to run dry when
operating the machine.
Replace the water tank in the proper position.
The steam wand
does not froth the
milk.
The frothing nozzle is
clogged or needs to be
descaled.
The milk is not cold or not
fresh enough.
The inner tube of the
frothing nozzle is not firmly
screwed in.
The shape of the container
is not appropriate for
frothing.
Carefully clean (see Section 7) or descale the
steam wand (see Section 8).
Use fresh, cold milk in a cold container.
Pasteurised or UHT milk is recommended. Whole,
lowfat, or skim milk can all be frothed. Try using a
different brand of milk.
Screw the inner nozzle firmly in place (see Section
7).
Use a small pitcher-shaped container with a small
diameter for best results. Also, chilling the
container before adding the milk will improve
results.
The pump is
unusually noisy.
No water in the tank.
The tank is not properly
positioned.
Stop the machine. Fill the water tank, replace in
the correct position, and turn the machine back on.
Replace the tank in the correct position.
The cups are not
filled equally.
The filter holder is clogged. Clean the filter holder (see section 7).
IFU Krups XP5220-XP5240 0828241B.qxd:0828241B 30/03/09 10:42 Page 9
Downloaded from CoffeeMachineManual.com Manuals

Krups XP5220 Specifications

General

Product type	Espresso machine
Capacity in cups	2 cups
Coffee input type	-
Water tank capacity	1.1 L
Maximum operating pressure	15 bar
Type	Espresso
Non-slip feet	Yes
Product color	Black, Stainless steel
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	262 mm
Width	228.6 mm
Height	292 mm
Weight	6170 g