WORK 10
100317-10
Warning
Forfeiture of homologation and insurance cover The vehicle is homologated
as 2-seater. If the heel protector is fitted instead of the footrest bracket, the
vehicle no longer conforms to the homologation and must not be operated in
this form without alterations to the registration papers.
– Set up and operate the vehicle as a 2-seater or have changes made to
the registration papers.
– Position the heel protector. Mount and tighten screws.
Guideline
Screw, heel protector M8x12 8Nm (5.9lbfft)
3.12Refueling
Danger
Fire hazard Fuel can easily catch fire.
– Never fill up the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
– Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See specifications on filling up with fuel.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
– Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse imme-
diately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed,
contact a doctor immediately. Change clothing that has come into contact with fuel.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
– Do not allow fuel to get into the ground water, the ground, or the sewage system.
Info
This motorcycle is equipped with a regulated catalyst. Leaded fuel will destroy the catalyst. You should therefore use unleaded
fuel only.
400405-10
– switch off engine.
– Open the filler cap. ( S. 8)
– Fill the fuel tank with fuel up to measurement.
Guideline
Measurement of 20mm (0.79in)
Fuel tank content 12l (3.2USgal) Super unleaded (ROZ 95 / RON 95 /
PON 91) ( S. 14)
– Close the filler cap. ( S. 8)
100240-10
– Press theSET function button for 2 seconds.
The fuel level warning lamp switches off. TRIPF is set to 0 and appears in
the previous display mode.
Info
If you do not press theSET function button, the reset takes place auto-
matically after about 3 minutes.
To Next Page
Loading...
Need help?
General
