G GENERAL
(2)
Check
Points
of
Initial 50
Hours
82410· 82710·
82910 WSM, 12271
Changing
Engine
Oil
A CAUTION
• Before
changing
oil, be
sure
to
stop
the
engine.
1.
Start and warm up the engine for approx. 5 minutes.
2.
Place
an
oil pan underneath the engine.
3.
To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4.
Screw
in
the drain plug (1).
5.
Fill new oil up to upper line on the dipstick (2).
• IMPORTANT
• When
using
an
oil
of
different
manufacture
or
viscosity
from
the
previous
one, remove
all
of
the
old
oil.
• Never
mix
two
different
types
of
oil.
• Use
the
proper
SAE
Engine
Oil
according
to
ambient
temperatures.
• Refer
to
"LUBRICANTS, FUEL AND
COOLANT".
(See page
G-8.)
3.0 L
82410 3.2 U.S.qts
Engine oil capacity
2.6Imp.qts
4.1
L
82710
4.3 U.S.qts
82910
3.6Imp.qts
(1)
Drain Plug
(2)
Dipstick
(3)
Oil Inlet
(A) Oil level
is
acceptable
within
this
range.
12271G00050
Replacing
Engine
Oil Filter
Cartridge
A CAUTION
• Be
sure
to
stop
the
engine
before
changing
oil
filter
cartridge.
1.
Remove the oil filter cartridge with the filter wrench.
2.
Apply a slight coat of oil onto the cartridge gasket.
3.
To install the
new
cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4.
After the
new
cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure
to
read the oil level on the
dipstick. Then, replenish the engine oil up to the specified level.
• IMPORTANT
• To
prevent
serious
damage
to
the
engine,
replacement
element
must
be
highly
efficient.
Use
only
a KUBOTA
genuine
filter
or
its
equivalent.
(1) Engine Oil Filter
12270G00070
G-12
To Next Page
Loading...
Need help?
General
